Related Manuals for Honeywell T80
Summary of Contents for Honeywell T80
- Page 1 Quick Guide...
- Page 2 OVERVIEW Receiver Scan Light Power Light Scan Scan Power Button Return Scan Enter F1 Key F2 Key Delete Microphone Speaker Scan window Type-C Flash lamp interface Camera Card HOME Reading area Power Button Battery cover Hot button/Custom button 1. Screen capture: "power"+"Volume -" 2.
-
Page 3: Strap Installation
STRAP INSTALLATION Buckle (As Pic1) Following the direction of the above arrow, push the strap buckle up to secure it. -
Page 4: Open The Battery Cover
OPEN THE BATTERY COVER 1. Push the battery cover button in anti-clockwise direction. (As Pic1) 2. Pull out the battery cover by using the hand position between the battery cover and the bottom case. Please remove the positive and negative insulation yellow sticker on the battery before turning on tne device. -
Page 5: Removing The Battery
REMOVING-THE BATTERY 1. Lift the strap on the battery: 2. Pull the battery belt to take the battery off on 45° obliquely upward. - Page 6 INSTALL TF/SIM CARD 1. Insert the SIM card into the corresponding slots as shown in the figure below TF slot PSAM slotx 2 Micro SIM slot (Note: The handheld terminal only supports Micro SIM card; the standard SIM card slot is for PSAM card)
- Page 7 EQUIPMENT CHARGING DEVICE CHARGING: 1. Pull out the waterproof USB plug on the right side with the Type-C USB cable that comes with the device.Insert the Type-C USB cable. Type-C interface 2. Use cradle to charge. (Cradle comes seperately) 1. Battery is fully charged after 4 hours of charging, and the standby time is over 48 hours.
- Page 8 SCAN(OPTIONAL) IF PDA COMES WITH SCAN FUNCTION, OPERATE AS BELOW: 1. Find the "scanner" app, and open it.(As Pic 1) 2. In the scan interface, press scan button to scan the barcode. (Pic1) Clear the Reset scan contents Function setting: Enter/Tab Settings Append prefix/...
- Page 9 NFC(OPTIONAL) IF PDA WITH NFC FUNCTION, OPERATE AS BELOW: 1. Find the “NFC" app, and open it.(As Pic 1) 2. In the NFC interface, please read the card by NFC reading area. (Pic1) (Pic 2) NFC reading Note: NFC function is optional feature, you should make sure PDA includes NFC function)
- Page 10 OTA(UPDATE ONLINE) OUR PDA SUPPORT OTA(UPDATE ONLINE)FUNCTION,YOU CAN UPDATE THE LATEST FIRMWARE BY OTA, OPERATE IT AS BELOW: 1. Select "Settings"- About phone. 2. Press "System update" and enter into the updating firmware interface. 3. Press "Check now" to update the OS. (As Pic1) (As Pic 2)
- Page 11 FAQ: 1. How to restore factory settings? Select “Setting”→“Backup&reset”→“Factory date reset" 2. Can’t start PDA? (1) If the new device does not turn on, please make sure the sticker on battery has been removed. (2) Pressing the power button need about 4s, so press the power button untill the screen showing contents.
- Page 12 COMMITTED TO THE WORLD OF THINGS CREATING A SMART LIFE...