Table of Contents
Figure 25. Remove the system cover
Remove an expansion card from an expansion card
riser
Prerequisites
Follow the safety guidelines listed in
About this task
NOTE:
This procedure describes and illustrate expansion card removal from each type of expansion card riser. Refer to the
applicable illustration to aid in removal of the expansion card from the expansion card riser.
NOTE:
When removing an expansion card from riser 2 or 3, ensure that the PCIe card holder latch is closed.
Steps
1. If applicable, disconnect the cables from the expansion card.
2. Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
60
Replace a PCIe HBA (SAS, FC, or NIC)
Safety instructions
on page 13.
Table of Contents
