Table of Contents
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 MCU
At the prompt, enter 3 to change Ethernet speed and duplex parameters.
Step 5
The network interface card settings screen appears as follows:
Enter either a number between 0 and 5 inclusive, representing the required option.
Step 6
We recommend using 5 (Auto) and the ethernet switch port to autonegotiate speed/duplex.
Step 7
Press any other key to quit without changing the network working mode.
Step 8
At the prompt, enter 4 to disable the DSP reset facility.
After options Q and 1-3, press any key to return to the EMP Main menu. After option 4, the EMP Main
Note
menu displays automatically.
Caution
Only qualified technical personnel should modify the DSP reset function settings.
Saving Network Configuration Settings
Modified network configuration settings are automatically saved when you exit the EMP Main menu.
Procedure
Ensure you have completed your configuration.
Step 1
At the prompt, enter Q to exit the video processing module Main menu.
Step 2
The video processing module Main menu closes and your machine will automatically reboot.
Connecting the EMP to the LAN
Procedure
Connect the supplied LAN cable from your network switch to the 10/100BaseT Ethernet port on the front
Step 1
panel of the EMP unit. The 10/100BaseT port accepts an RJ-45 connector.
We recommend setting the network switch port to auto-negotiate speed/duplex.
Turn on the power to the EMP unit.
Step 2
OL-17013-01
Choose : 1 - 10Mbps
Half Duplex
: 2 - 100Mbps Half Duplex
: 3 - 10Mbps
Full Duplex
: 4 - 100Mbps Full Duplex
: 5 - Auto
other - Quit
:
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
How to Perform the Initial EMP Configuration
2-27
Table of Contents
