HP ProCurve 1400-24G Installation And Getting Started Manual page 22

Installing the Switch

Installation Procedure

Removing the mini-GBICs:

N o t e

You should disconnect the network cable from the mini-GBIC before

removing it from the switch.

Depending on when you purchased your ProCurve mini-GBIC, it may have

either of three different release mechanisms: a plastic tab on the bottom of

the mini-GBIC, a plastic collar around the mini-GBIC, or a wire bail.

To remove the mini-GBICs that have the plastic tab or plastic collar, push the

tab or collar toward the switch until you see the mini-GBIC release from the

switch (you can see it move outward slightly), and then pull it from the slot.

To remove the mini-GBICs that have the wire bail, lower the bail until it is

approximately horizontal, and then using the bail, pull the mini-GBIC from the

slot.

Replace the protective plastic cover on the mini-GBIC.

2-12