Table of Contents
Available languages
Available languages
en-us
Substance
Benzene
Carbofuran
p-Dichlorobenzene
Lead pH = 6.5
Lead pH = 8.5
Mercury pH = 6.5
Mercury pH = 8.5
Turbidity
Ethylbenzene
Toxaphene
Asbestos
Cyst
Meprobamate
Atenolol
Carbamazepine
DEET
Phenytoin
Metolachlor
Ibuprofen
Trimethoprim
Linuron
Naproxen
Estrone
Bisphenol A
Nonyl phenol
Tested using a flow rate of 0.55 gpm (2.0 L/min), pH of 7.5 ± 0.5, pressure of 60 psig, and temperature of 68 ± 5 °F.
NOTE : The testing was performed under standard laboratory conditions, actual performance may vary.
Operation conditions
Service flow rate
Water pressure
Water temperature
Function
Capacity
Warning: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst reduction may be used on disinfected water that may contain
filterable cyst.
Note:
Adsorption media will not be regenerated and used.
■
Systems must be installed and operated in accordance with manufacturer's recommended procedures and
■
guidelines. The system and installation shall comply with applicable state and local regulations. Install on cold water
line only.
Flush 3 gallons through filter before use (flush approximately 5 minutes).
■
To maintain proper filtration, replace the filter at least every 6 months.
■
Manufacturer: Microfilter co.,Ltd.
15-1, GWINONG3-GIL, DEOKSAN-MYEON, JINCHEON-GUN, CHUNG-BUK 27856, KOREA
Phone: +82-43-531-7022/7024
24
Influent challenge
Average reduction
concentration
0.015 mg/L ± 10 %
0.08 mg/L ± 10 %
0.225 mg/L ± 10 %
0.15 mg/L ± 10 %
0.15 mg/L ± 10 %
0.006 mg/L ± 10 %
0.006 mg/L ± 10 %
11 ± 1 NTU
2.1 mg/L ± 10 %
0.015 mg/L ± 10 %
10
to 10
fibers/L;
7
8
fibers greater than
10 μm in length
minimum 50,000/L
400 ng/L ± 20 %
200 ng/L ± 20 %
1,400 ng/L ± 20 %
1,400 ng/L ± 20 %
200 ng/L ± 20 %
400 ng/L ± 20 %
400 ng/L ± 20 %
140 ng/L ± 20 %
140 ng/L ± 20 %
140 ng/L ± 20 %
140 ng/L ± 20 %
2,000 ng/L ± 20 %
1,400 ng/L ± 20 %
0.55 gpm (2 L/m)
30 psi - 120 psi (206 - 861 kPa)
35 °F - 100 °F (2 °C - 38 °C)
chemical/mechanical
WFS200MF 250 gallons (946 L), WFS210MF 150 gallons (567 L)
Reduction
requirement
>96.8 %
N/A
>98.8 %
N/A
>99.8 %
N/A
>98.8 %
N/A
97.9 %
N/A
>96.5 %
N/A
>96.6 %
N/A
99.1 %
N/A
>99.9 %
N/A
N/A
>99 %
99 %
99.99 %
99.95 %
>95.2 %
N/A
>95.6 %
N/A
>98.6 %
N/A
>98.7 %
N/A
>94.4 %
N/A
>98.7 %
N/A
>95.3 %
N/A
>96.7 %
N/A
>96.6 %
N/A
>96.2 %
N/A
>96.3 %
N/A
>99.0 %
N/A
>96.3 %
N/A
Max. permissible
product water
concentration
0.005 mg/L
0.04 mg/L
0.075 mg/L
0.010 mg/L
0.010 mg/L
0.002 mg/L
0.002 mg/L
0.5 NTU
0.7 mg/L
0.003 mg/L
N/A
N/A
60 ng/L
30 ng/L
200 ng/L
200 ng/L
30 ng/L
200 ng/L
60 ng/L
20 ng/L
20 ng/L
20 ng/L
20 ng/L
300 ng/L
200 ng/L
Chapters
Table of Contents
