Page 1
GRT12M THREE-PHASE CUTTING UNIT USE MANUAL...
Page 2
All the parts of the devices have been designed and produced to guarantee an optimum performance. In order to keep the high quality level and the long reliabilty of the Rasor ® products, it is recommended using only original spare parts and contacting the head office...
1. GENERAL SAFETY RULES This manual is an integral part of cutting unit GRT12M and must be carefully read before using it since it gives important indications with regards to its safe installation, use and maintenance. Keep it with care.
Page 4
Moreover, they cannot work in case of rain. In case of damage or malfunction, cutting unit GRT12M must not be used until the Customer Care Technical Service has repaired it.
In such a case, the operator is the only person responsible. Model R EAD SHEARING Serial number T H E MM_______ GRT12M R ISK INSTRUCTION 0,52 Electric data MANUAL Year of production 2___...
4. PRODUCT DESCRIPTION The fixture described in this manual is a cutting unit model GRT12M which can be assembled on automatic machines (e.g. spreaders, computerized cutting) by means of proper holes located in the motor support. GRT12M can operate continuously and it can cut at various heights by means of multiple installation.
Page 7
The technical data are only indicative and they can be changed without notice. 6. NOISE LEVEL The maximum acoustic pressure level emitted by cutting unit GRT12M is about 60 dB (A). Noise tests have been carried out in compliance with Standard UNI EN ISO 11202:2010. The device noise levels, measured at different distances (without any sound wave filtering system), vary in the extent of few db (A).
· Always pay attention to the electric cable position to prevent it from being cut or damaged by the blade. · It is allowed to assemble cutting unit GRT12M on machines O.E.M. on condition that their original structure is not modified. Otherwise, the intervention must be certified by Rasor ®...
6) Carry out the cutting operation. NOTE Cutting unit GRT12M can work in a fixed position (the material has to be moved) or it can move forward while the material is kept in the same position. Make sure the material to be cut is properly stretched, preventing it from curling.
To carry out this operation, remove the protective plug “A” located on the motor support of the cutting unit and fill it with lubricating grease Rasor. Screw plug “A” again a few turns. Screw plug “A” a few turns every 2-3 working days (see picture 9).
15. TROUBLESHOOTING PROBLEM SOLUTION à Check that the blade and the counterblade are touching each other Check the kind of fabric Sharpen the blade The fabric is not cut or it gets stuck between Check the fabric thickness the blade and the counterblade Check the compatibility between blade and fabric Make sure that the motor turns correctly Reduce the feeding speed...
The warranty covers all manufacturing and material defects. Replacement and repair operations are covered only if carried out by our company and at our workshop. If in-warranty goods need to be repaired, the customer must always send the complete machine to Rasor ®...