Table of Contents
INSTALLING THE OPTIONAL RESERVOIR ROLL COVERS
Note: Universal coders are designed to receive the ink required for printing from the capacity of a pre-saturated
ink roll. The optional 4 oz. Reservoir Ink Cartridges are intended to be used only for the purpose of automatic re-
inking when the ink roll becomes depleted of ink. Always allow the coder to run without a 4 Oz. Reservoir
Cartridge installed until the print quality indicates a need for additional ink. Do not install a Reservoir Cartridge
when the Ink Roll is fully saturated or over saturation and dripping will result.
1- To install the Reservoir Roll Cover, remove the Ink Roll
Mounting Screw and Axle Cap.
2- Place the Reservoir Roll Cover over the ink roll with the
open side facing the Print Drum.
3- Install and tighten the Mounting Screw.
Note: The standard Axle Cap is not used when a
Reservoir Roll Cover is installed on the coder. Use
only the flat washer supplied with the cover.
INSTALLING THE 4 OZ. RESERVOIR INK CARTRIDGES
1- When the ink roll requires more ink, remove the white cap
from the 4oz. bottle and screw it into the threaded port on
the Reservoir Roll Cover. Hold the bottle straight during in-
stallation and be careful not to cross the threads. The bottle
must be threaded into the port until it stops.
When fully seated in the port, the plastic ball in the tip of the 4 Oz. Ink
Cartridge will contact the surface of the Ink Roll. After installing the 4
Oz. Cartridge, the print quality should return to normal within a few sec-
onds on top mount machines, slightly longer on side mount machines.
When the reservoir ink cartridge is empty, do not immediately install a new cartridge. Remove the empty car-
tridge and wait until the print quality begins to show signs of needing ink before installing a new one. This will
prevent the ink roll from becoming over saturated.
MAINTENANCE
22
FIGURE 36
FIGURE37
FIGURE 38
FIGURE 39
Table of Contents
