Functional Description; Depth Adjustment - Makita FS4000 Instruction Manual
Drywall screwdriver
Hide thumbs
Also See for FS4000:
- Instruction manual (49 pages) ,
- Technical information (7 pages) ,
- Instruction manual (33 pages)
Table of Contents
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product.
MISUSE or failure to follow the safety rules stated
in this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Depth adjustment
A
B
► 1 . Lock ring
The depth can be adjusted by turning the lock ring. Turn
it in "B" direction for less depth and in "A" direction for
more depth. One full turn of the lock ring equals 2.0 mm
change in depth.
Adjust the lock ring so that the distance between the
tip of the locator and the screw head is approximately 1
mm as shown in the figures. Drive a trial screw into your
material or a piece of duplicate material. If the depth is
still not suitable for the screw, continue adjusting until
you obtain the proper depth setting.
1mm
► 1 . Locator
1
1
1mm
► 1 . Locator
Switch action
1
2
► 1 . Switch trigger 2. Lock button
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
NOTE:
•
Even with the switch on and motor running, the
bit will not rotate until you fit the point of the bit
in the screw head and apply forward pressure to
engage the clutch.
4 ENGLISH
1
Table of Contents
