Table of Contents
10.2 Checking the battery
Please note that in case you have to change the battery, it must be done only in a safe area.
Refer to section 10.3 "Battery replacement".
10.2.1 Before starting gauging
Switch on the unit. The buzzer tones every 2 seconds if the battery is not too low.
The following sequences are displayed as per Figure 10-1, the 4
the battery in percentage and as a bar-graph.
If the power left is less than 50% we recommend to have a spare battery ready for exchange. See also 10.3
"Battery replacement".
If the power left is less than 20% the message is blinking to advise that the power may not be enough to
carry out all the work.
If the battery is too low, the unit will stop on the message "battery" as shown on Figure 10-2 and the buzzer
tones continuously. Change the battery as per 10.3 "Battery replacement".
If it is not possible to switch on the unit, the battery is out or work. Change the battery first, as per 10.3
"Battery replacement".
50461/GTEX MMC/1111
UTImeter
ON
Ver x.xx
Battery
ééééé 97%
Init.
*********
25.94°C
Figure 10-1
UTImeter
ON
Ver x.xx
Battery
0%
░
Init.
*********
Battery
Figure 10-2
36
th
sequence shows the remaining power of
UTImeter Gtex MMC
Table of Contents
