GE JDS28 Owner's Manual page 19
Electric drop-in ranges
Hide thumbs
Also See for JDS28:
- Owner's manual (25 pages) ,
- Installation instructions manual (17 pages) ,
- Owner's manual (48 pages)
Table of Contents
Problem
Oven temperature too
hot or too cold
Oven will not work
"Crackling" or
"popping" sound
"F – and a number
or letter" flash
in the display
Display flashes "bAd"
then "linE" with a
loud tone
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
Possible Causes
Oven thermostat
needs adjustment.
Plug on range is not
completely inserted in
the electrical outlet.
A fuse in your home may
be blown or the circuit
breaker tripped.
Oven controls improperly set.
This is the sound of the
metal heating and cooling
during the cooking functions.
You have a function
error code.
If the function code repeats.
The installed connection
from the house to the unit
is miswired.
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is turned off from • See the Using the clock and timer section.
showing in the display.
Power failure.
Oven control pads were
not pressed properly.
Power outage or surge.
What To Do
• See the Adjust the oven thermostat—Do it yourself!
section.
• Make sure electrical plug is plugged into a live,
properly grounded outlet.
• Replace the fuse or reset the circuit breaker.
• See the Using the oven section.
• This is normal.
• Press the CLEAR/OFF pad. Put the oven back into
operation.
• Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Contact installer or electrician to correct miswire.
• Replace the fuse or reset the circuit breaker.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be pressed
at the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
ge.com
19
Table of Contents
