Ice Maker Cleaning - Hitachi R-S42GS How To Use Manual

● Do not place your hand in the mechanical section

Warning

Wash the Ice Tray or water paths with water.

Be sure to check the followings before

starting the operation.

Go to the next step after checking them.

1

Close all the doors.

2

Hold down " Ice Maker " button for 5 seconds or more until

the alarm sounds.

When the 3 indicator lamps " Quick " , " On " and " Off " start to blink and alarm starts to sound, stop

holding the button.

" Ice Maker Cleaning " starts (for about 4 minutes).

・ The indicator lamp will flash and the buzzer will sound for about 4 minutes.

・ " Ice Maker Cleaning " can ' t be interrupted.

・ If you open any of the refrigerator doors during Ice Maker Cleaning, the cleaning may not work

properly. Do not open or close the door until cleaning is completed.

・ Door alarm sounds even if alarm is disabled.

3

Place a clean towel, etc. on the bottom in the Ice Case so

that the cutout of the Ice Case can be blocked after the

alarm and blinking of the indicator lamp end.

Place a water-absorbing towel on the bottom in the Ice Case to prevent trapped water from spilling

out of the cutout of the Ice Case during the ice maker cleaning.

4

Wipe off water inside the Ice Case completely, and then set

it to the Ice Compartment.

Remove the towel with which you have wiped off water. There is no problem with using water

remaining in the water supply container, if any.

After "製冰機清潔 (Ice Maker Cleaning) " , it is set to " On " mode, etc.

of the automatic ice maker.

(Rotation of the ice tray may cause injury.)

When using for the first time

Pg.48

When not used for more than one week

Water supply container

・ Water is filled in it up to the limit line.

・ It is set correctly beyond the tank

set position line.

Ice case

・If there remains ice, remove it.

Blinking

Push it

Cutout

Towel

51