Table of Contents
Quick Links
Table of Contents
Related Manuals for Bosch Autodome Inteox 7000i-2MP
Summary of Contents for Bosch Autodome Inteox 7000i-2MP
- Page 1 AUTODOME inteox 7000i ‑ 2MP (in‑ceiling) Installation Manual...
-
Page 3: Table Of Contents
10.5 Alarms and Relay Connections 10.6 Audio Connections (Optional) Troubleshooting 11.1 Rebooting the unit 11.2 Physical reset button 11.3 Customer Service and Support Maintenance Technical data Support services and Bosch Academy Bosch Security Systems 2021-08 | 1.4 | Installation Manual... -
Page 4: Safety En
Legal Information Copyright This manual is the intellectual property of Bosch Security Systems, and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly. -
Page 5: Important Safety Instructions
For 24 VAC units, voltage applied to the unit's power input should not exceed ±10%, or 28 VAC. User-supplied wiring must comply with local electrical codes (Class 2 power levels). Do not ground the supply at the terminals or at the unit's power supply terminals. Bosch Security Systems 2021-08 | 1.4 | Installation Manual... - Page 6 16. Attachments, changes or modifications - Only use attachments/accessories specified by the manufacturer. Any change or modification of the equipment, not expressly approved by Bosch, could void the warranty or, in the case of an authorization agreement, authority to operate the equipment.
- Page 7 Notice! Bosch recommends the use of surge/lightning protection devices (sourced locally) to protect network and power cables and the camera installation site. Refer to NFPA 780, Class 1 & 2, UL96A, or the equivalent code appropriate for your country/region, and to local building codes.
-
Page 8: Important Notices
Camera signal - Protect the cable with a primary protector if the camera signal is beyond 140 feet, in accordance with NEC800 (CEC Section 60). Environmental statement - Bosch has a strong commitment towards the environment. This device has been designed to respect the environment as much as possible. - Page 9 Ce produit est un appareil de Classe A. Son utilisation dans une zone résidentielle risque de provoquer des interférences. Le cas échéant, l’utilisateur devra prendre les mesures nécessaires pour y remédier. Bosch Security Systems 2021-08 | 1.4 | Installation Manual...
- Page 10 Any such modifications could void the user's authority to operate the equipment. If necessary, the user should consult the dealer or an experienced radio/television technician for corrective action. 2021-08 | 1.4 | Bosch Security Systems Installation Manual...
-
Page 11: Customer Support And Service
AUTODOME inteox 7000i - 2MP (in-ceiling) Safety EN | en Customer Support and Service If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions. USA and Canada Telephone: 800-289-0096, option 5 Fax: 800-366-1329 Email: [email protected]... -
Page 12: Unpacking
Sales or Customer Service Representative from Bosch Security Systems. – Do not use this product if any component appears to be damaged. Please contact Bosch Security Systems in the event of damaged goods. – The original packing carton (if undamaged) is the safest container in which to transport the unit and must be used if returning the unit for service. -
Page 13: Product Description
The camera has been designed for quick and easy installation, a key feature from Bosch IP video security products. All housings feature recessed screws and latches for increased tamper resistance. -
Page 14: Preparing The Bubble
Notice! To avoid excessive moisture saturation inside the housing, limit the amount of time that the bubble is disconnected from the housing. Bosch recommends that the bubble be removed from the housing for no more than five (5) minutes. Remove the bubble from an in-ceiling housing Loosen the lockscrew (item 1 in the illustration below) in the trim ring using a P1 or smaller Phillips screwdriver until the bubble can rotate freely. - Page 15 Never scrub the bubble with any abrasive material or cleaners. Bosch recommends cleaning the exterior of the bubble with NOVUS “No. 1” Plastic Clean & Shine (or equivalent), according to manufacturer’s instructions. Refer to www.novuspolish.com...
-
Page 16: Optional) Installing An Sd Card
Follow the steps in one of these sections (depending on the type of camera mount): Replace the bubble in an in-ceiling housing or Replace the bubble in a pendant housing. 2021-08 | 1.4 | Bosch Security Systems Installation Manual... -
Page 17: Replacing The Trim Ring And Bubble
Forcing the screw into the trim ring (without the screw going into the screw slot in the housing) can deform the ring. Erase the chalk or pencil mark if desired. Bosch Security Systems 2021-08 | 1.4 | Installation Manual... -
Page 18: Installing The In-Ceiling Mount
Place the Bracket Assembly over the ceiling tile, which is used to mount the camera. Snap the Bar Clips of the bracket to the ceiling rails. 2021-08 | 1.4 | Bosch Security Systems Installation Manual... -
Page 19: Installing The Ceiling (Ip54 Housing) Gasket
Place the gasket (provided in the shipping box of the camera) over the top of the in- ceiling housing. Carefully slide the gasket down over the housing, until it rests on the flange of the housing. Bosch Security Systems 2021-08 | 1.4 | Installation Manual... -
Page 20: Attach Housing To The Interface Box
Tighten the two (2) Thumbscrews to secure the Interface Box to the housing. Figure 7.4: In-Ceiling Housing and Interface Box Interface Box Thumb Screw Ball Stud Tether Point In-ceiling Housing Ceiling Clamp 2021-08 | 1.4 | Bosch Security Systems Installation Manual... -
Page 21: Secure Housing To Ceiling
Tighten both clamps using a #2 Phillips screwdriver, to secure the housing to the ceiling. 40 mm 1.57 in. MAXIMUM CEILING 6.5 mm 0.26 in. MINIMUM CEILING inches Figure 7.5: Secure camera to ceiling Tether Point Ceiling Clamp Ceiling Clamp Rotate Clockwise to Engage Clamp Bosch Security Systems 2021-08 | 1.4 | Installation Manual... - Page 22 Over-torquing the Ceiling Clamps can damage the clamp or ceiling. Only tighten the clamp until it contacts the ceiling and you start to feel some resistance. If using a power screwdriver, set the torque level to the lowest setting. 2021-08 | 1.4 | Bosch Security Systems Installation Manual...
-
Page 23: Finalizing Installation
AUTODOME inteox 7000i - 2MP (in-ceiling) Finalizing installation | en Finalizing installation Remove the plastic on the bubble After you complete all other installation steps, remove the plastic material that is protection for the bubble. Bosch Security Systems 2021-08 | 1.4 | Installation Manual... -
Page 24: Replacing An In-Ceiling Hd Acrylic Bubble
Forcing the screw into the trim ring (without the screw going into the screw slot in the housing) can deform the ring. 2021-08 | 1.4 | Bosch Security Systems Installation Manual... -
Page 25: Connection
TCP/IP network using the built-in Web server. In addition, power can be supplied over the Ethernet cable using the Bosch High PoE 60W midspan (sold separately). Power can also be supplied Bosch Security Systems 2021-08 | 1.4 |... - Page 26 Which is correct? Here is the original: Warning! Bosch High PoE or PoE+ (802.3at): Use only approved High PoE or PoE+ (802.3at) devices. For outdoor pendant applications that require heater power use only the Bosch High PoE midspan (sold separately) to power the camera and the heaters. For in-ceiling or indoor pendant applications that don't require heater power, standard PoE+ (802.3at) midspans or...
-
Page 27: Fiber Optic Ethernet Media Converter (Optional)
Connection | en Warning! BOSCH High PoE or PoE+ (802.3at): Use only approved High PoE or PoE+ (802.3at) devices. For outdoor pendant applications that require heater power use only the Bosch High PoE midspan (sold separately) to power the camera and the heaters. For in-ceiling or indoor pendant applications that don't require heater power, standard PoE+ (802.3at) midspans or... -
Page 28: Alarms And Relay Connections
Install a 2.2 K end-of-line resistor in the alarm circuit. Connect the alarm wires to input 1 or 2 (pin 5 or 6) and to the ground (pin 7) at the camera. 2021-08 | 1.4 | Bosch Security Systems Installation Manual... - Page 29 Alarm input. In the field Active, select N.C.S.. Finally, select an Action . See the table below for contact and condition details. AUTODOME Programmed N.C.S. Contact Alarm Condition Open Alarm Closed Normal Short Tamper Bosch Security Systems 2021-08 | 1.4 | Installation Manual...
- Page 30 From Configuration, select Alarm > Alarm Inputs. For Input 1, enter a Name for the Alarm input. In the field Active, select N.C.. Finally, select an Action.See the table below for contact and condition details. AUTODOME Programmed N.C. Circuit Alarm Indication Open Alarm 2021-08 | 1.4 | Bosch Security Systems Installation Manual...
-
Page 31: Audio Connections (Optional)
Internal gain level adjustment is available in case the signal level is too low. Audio Line Output Specifications The following Line Output specifications should be complied with in all cases. Typical Output 1 Vrms Voltage Bosch Security Systems 2021-08 | 1.4 | Installation Manual... - Page 32 Connect the audio line level output signal ground to the Audio_Out- (TXD) output terminal. Figure 10.5: Connections for audio over an Ethernet network Audio_In- (C-) AUTODOME Data In/Out Audio_In+ (C+) P105/P106 Connector Earth Ground Audio Out Audio_Out+ (RXD) Audio_Out– (TXD) Signal Ground 2021-08 | 1.4 | Bosch Security Systems Installation Manual...
- Page 33 AUTODOME inteox 7000i - 2MP (in-ceiling) Connection | en Notice! Separate the audio cables from the AC power lines to avoid noise. To configure audio on the camera, refer to Basic Mode: Audio or Audio. Bosch Security Systems 2021-08 | 1.4 | Installation Manual...
-
Page 34: Troubleshooting
If you cannot control the unit after the firmware upgrade, then cycle the power to the unit. If a power reset does not solve the problem, or if Configuration or video management software identifies the unit as “Videojet Generic,” then contact your Bosch Service Center for an RMA for the unit. -
Page 35: Physical Reset Button
Let the camera complete a self-check. When the self-check completes, the red LED will go off. Find the IP address again. Access the camera using the web browser. Set the initial service-level password for the camera. Bosch Security Systems 2021-08 | 1.4 | Installation Manual... - Page 36 | Troubleshooting AUTODOME inteox 7000i - 2MP (in-ceiling) 2021-08 | 1.4 | Bosch Security Systems Installation Manual...
-
Page 37: Customer Service And Support
AUTODOME inteox 7000i - 2MP (in-ceiling) Troubleshooting | en 11.3 Customer Service and Support If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions. USA and Canada Telephone: 800-289-0096, option 5 Fax: 800-366-1329 Email: [email protected]... -
Page 38: Maintenance
Never scrub the bubble with any abrasive material or cleaners. Bosch recommends cleaning the exterior of the bubble with NOVUS “No. 1” Plastic Clean & Shine (or equivalent), according to manufacturer’s instructions. Refer to www.novuspolish.com... -
Page 39: Technical Data
AUTODOME inteox 7000i - 2MP (in-ceiling) Technical data | en Technical data For product specifications, see the datasheet for your camera, available on the appropriate product pages of the Online Product Catalog at www.boschsecurity.com. Bosch Security Systems 2021-08 | 1.4 | Installation Manual... -
Page 40: Support Services And Bosch Academy
– Troubleshooting – Repair & Exchange – Product Security Bosch Building Technologies Academy Visit the Bosch Building Technologies Academy website and have access to training courses, video tutorials and documents: www.boschsecurity.com/xc/en/support/training/ 2021-08 | 1.4 | Bosch Security Systems Installation Manual... - Page 41 AUTODOME inteox 7000i - 2MP (in-ceiling) Support services and Bosch Academy | Bosch Security Systems 2021-08 | 1.4 | Installation Manual...
- Page 42 | Support services and Bosch Academy AUTODOME inteox 7000i - 2MP (in-ceiling) 2021-08 | 1.4 | Bosch Security Systems Installation Manual...
- Page 44 Bosch Sicherheitssysteme GmbH Bosch Security Systems, LLC Robert-Bosch-Ring 5 1706 Hempstead Road 85630 Grasbrunn Lancaster, PA, 17601 Germany www.boschsecurity.com © Bosch Sicherheitssysteme GmbH, 2021 202109102315...