Table of Contents
ENGINE DISASSEMBLY / INSPECTION - TOP END
VALVE COVER REMOVAL
NOTE
The valve cover, camshafts, cylinder head, cylinder and
piston can be serviced with the engine installed in the
chassis.
1. If needed, remove the spark plug wire from the
engine.
2. Remove dirt and debris from valve cover area.
3. Remove the three valve cover shoulder bolts
w
isolators
using a T40 driver.
4. Carefully lift valve cover from the engine and remove
it out of the right-hand rear wheel well area.
w
5. Replace isolators
and valve cover seal
leaks are evident.
r
6. Remove the spark plug
a shop towel to prevent anything from falling into the
combustion chamber (if further engine disassembly
is required).
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
q
and
e
if oil
. Stuff spark plug hole with
ENGINE / COOLING SYSTEM
CAMSHAFT / CARRIER REMOVAL
NOTE
The camshafts can be removed with the engine
installed in the chassis.
1. Rotate the engine so the piston is at Top Dead
Center (TDC) on the compression stroke.
NOTE
To verify TDC, see the
"SETTING TDC", page
2. Remove the hydraulic cam chain tensioner
the cylinder. Replace the sealing washer
reassembly.
section in this chapter.
t
from
y
upon
3.39
3
Chapters
Table of Contents
Troubleshooting
