Connect The Cable To The Outdoor Unit; Pipe Insulation - Panasonic WH-UD03JE5 Series Installation Manual

5

(FOR DETAIL REFER TO WIRING DIAGRAM AT UNIT)

1. Remove the control board cover from the unit by loosening the screw.

2. Connecting cable between indoor unit and outdoor unit shall be approved polychloroprene sheathed fl exible cable

(see below table), type designation 60245 IEC 57 or heavier cable.

Model

WH-UD03JE5* and WH-UD05JE5*

WH-UD07JE5* and WH-UD09JE5*

Terminals on the indoor unit

Colour of wires

Terminals on the outdoor unit

3. Secure the cable onto the control board with the holder (clamper).

4. Attach the control board cover back to the original position with screw.

WIRE STRIPPING AND CONNECTING REQUIREMENT

Wire stripping

No loose strand when insert

6

1. Please carry out insulation at pipe connection portion as mentioned in Indoor/Outdoor Unit Installation Diagram. Please wrap the

insulated piping end to prevent water from going inside the piping.

2. If drain hose or connecting piping is in the room (where dew may form), please increase the insulation by using POLY-E FOAM with

thickness 6 mm or above.

10

Flexible cable specifi cation

2

4 x (1.5 mm

)

4 x (2.5 mm

2

)

1

2

3

1

2

3

Indoor/outdoor

connecting

terminal board

5 mm or more

(gap between wires)

Terminal Board

1

2

3

Holder (Clamper)

WARNING

This equipment must be properly earthed.

Conductor

Conductor

over insert

fully insert

ACCEPT

PROHIBITED

Earth Wire

must be longer

than others

cables for

safety reason.

Conductor not

fully insert

PROHIBITED