Table of Contents
4
|
Operation
4.4.6 Room thermostat control - Using the leaving water temperature home pages
Typical leaving water temperature home pages
To read out the desired leaving water temperature (main + additional)
User reference guide
22
▪
You are using the following room temperature schedule:
-
08:00 preset value (Comfort) = 20°C
-
23:00 preset value (Eco) = 18°C
▪
At 14:00, you go away for 3 hours.
Then you can do the following:
1 Set the overrule period (Temperature lock) to 2 hours.
2 Go to the room temperature home page (Room).
3 Press
to select .
Result: For the next 2 hours, the room will NOT be heated to the scheduled 20°C,
but to the preset value (Eco = 18°C). After 2 hours, the room will heat up again to
the scheduled 20°C.
Advantage:
You save energy because you do NOT heat the room unnecessary, and by the time
you come home the room is warm again.
INFORMATION
The leaving water is the water that is sent to the heat emitters. The desired leaving
water temperature is set by your installer in accordance with the heat emitter type.
Example: Underfloor heating is designed for lower leaving water temperature than
radiators and heat pump convectors and/or fan coil units. You only have to adjust
leaving water temperature settings in case of problems.
Main zone:
User profile = Basic
35°C
Desired temperature
Additional zone:
User profile = Basic
45°C
Desired temperature
Go to the leaving water temperature home page (LWT main or LWT add).
User profile = Detailed
Mon
15:20
35°C
LWT main
Desired temperature
Mon
User profile = Detailed
Mon
15:20
45°C
LWT add
Desired temperature
Mon
EHYHBH05AF + EHYHBH/X05+08AF + EHYKOMB33AA
Mon
15:20
LWT main
17:30
Mon
15:20
LWT add
17:30
Daikin Altherma hybrid heat pump
4P355632-1E – 2020.10
Table of Contents
