Power Tools Service Manual CONFIDENTIAL Jul. 2020 PRODUCT NAME 18 V Cordless Impact Driver Drill DV 18DD, DV 18DDX Models *1: “Cordless Combi Drill” for Europe *2: Designed for operating in UK only CONTENTS Page REPAIR GUIDE ----------------------------------------------------------------------------------------------------------------- 1 1. Precautions on disassembly and reassembly ------------------------------------------------------------ 1 •...
1. Precautions on disassembly and reassembly [Bold] numbers in the description below correspond to the item numbers in the parts lists and exploded assembly diagrams for the Models DV 18DD and DV 18DDX. Disassembly 1. Removal of the drill chuck (1) For removal of the Drill Chuck [2] from the drill body, first use a vise to clamp the drill body, and then go to steps (a) and (b) below.
Page 3
2. Disassembly of housing (A).(B) set (1) Remove the eight Tapping Screws (W/Flange) D3 x 16 [4] from the drill body, hold Housing (A).(B) Set [11] at its battery mount portion, and then gently open Housing (A).(B) Set [11]. (2) Remove housing (B) and remove such built-in parts as modules and units. Lift up Gear Box (C) [3] to remove the built-in parts together from housing (A).
Reassembly Generally, perform reassembly by reversing the disassembly procedure. However, special attention should be given to the following items. 1. Reassembly of the power supply unit and its vicinity • Reassembly of the power supply unit and its vicinity Fit the protrusion of the direction selector lever of the switch into the hole of the Pushing Button [7].
Page 5
2. Reassembly of housing (A).(B) set (1) Mount the reassembled power supply unit and Gear Box (C) [3] in housing (A). (2) Check that the protrusion of the direction selector lever of the DC-speed control switch is correctly put in the hole of the Pushing Button [7].
Checking after reassembly After reassembly, install the battery in the tool body and check for operation of each component as follows. (1) Checking for lighting of the LED light Make sure the LED light turns on while pulling the switch and automatically turns off in about ten seconds when you release your finger from the switch.
Wiring diagram Mode-switching dial • Wiring diagram Clutch dial Insert the internal wire into the internal wire threading groove. [10] • Connecting diagram LD (green) - (black) Battery terminal + (red) Controller DC-speed control switch 2. Precautions on disassembly and reassembly of the charger Refer to the Service Manual for precautions on disassembly and reassembly of the charger Models UC 18YFSL and UC 18YKSL.