Table of Contents
3.2
Install fire detector
The S-Quad (Part No. S4-715) must be aligned to the detector base and mounted by turning the detector
clockwise into the base until it engages.
The S-Quad is connected and powered via the loop of the Fire alarm control panel.
Alarm and fault messages are transmitted via the loop to the connected Fire alarm control panel and indicated
on the panel display.
An activated alarm is also local indicated with the flashing red detector LED
mounted detectors in the air duct kit through the transparent cover.
Fig. 22: Insert S-Quad sensor
•
An external remote indicator may be connected if required.
•
It is recommended to use the removal tool to insert/remove the detector from the base.
•
Fix flow indicator (supplied Film strip) inside the cover (refer to Fig. 25).
•
Replace cover in correct positional arrangement.
Fig. 23: Flow indicator (Film strip)
4188-971_issue 1_07/09_duct sensor kit
www.acornfiresecurity.com
www.acornfiresecurity.com
S4-34760_Venturi-Air Duct Kit
. The LED is visible for the
13
Table of Contents
