Hardware Specifications - Cisco 2610 Datasheet

Feature

Alarm Detection

Relevant Management Information

Base (MIB) Support

Remote Management

Signaling Debugging

Table 4 shows the hardware specifications for the Cisco E1/T1 ISDN PRI Network Module.

Table 4.

Hardware Specifications for the Cisco E1/T1 ISDN PRI Network Module

Feature

Dimensions (H x W x D)

Operating Temperature

Nonoperating Temperature

Relative Humidity

LEDs

Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.

Description

•

Controller local loopback

•

Controller remote loopback

CSU loopback modes for T1 CSU

•

Data terminal equipment (DTE) loopback

•

Network loopback

•

Payload loopback

•

V.54

•

Yellow Alarm—Receive/Send from/to network

•

Blue Alarm—Receive alarm indication signal (AIS) from network

•

Red Alarm—Loss of network signal

•

RFC1406-MIB

•

CISCO-ICSUDSU-MIB

•

Supported by Cisco WAN Access Performance Management System (WAPMS)

•

Cisco Intelligence Engine (IE2100)

•

CiscoWorks

•

CAS debugs

•

ISDN Q.921 and Q.931 decode

•

All other previously existing applicable Cisco IOS debugs

Description

•

1.55 x 7.10 x 7.2 inches

•

3.9 x 18.0 x 18.3 centimeters

32 to 104° F (0 to 40° C)

–40 to 185° F (–40 to 85° C)

5-95% non-condensing

LEDs per port

•

T1: T1 mode selected

•

E1-BAL: E1 balanced mode selected

•

E1-UNBAL: E1 unbalanced mode selected

•

CD: Carrier detect

•

LP: Loop condition present

•

RA: Remote alarm detected

•

LA: Local alarm detected

© 2005 Cisco Systems, Inc. All rights reserved.

Page 4 of 8