Fan Speed Setting; Ventilation - Mitsubishi Electric SVZ-KP12NA Operation Manual

Hide thumbs Also See for SVZ-KP12NA:

Table of Contents

Available languages

3.2 Fan speed setting

NOTE

In the following cases, the actual fan speed generated by the unit will differ from the speed

shown the remote controller display.

1. When the unit is in STAND BY or DEFROST states.

2. When the temperature of the heat exchanger is low in the heating mode. (e.g.

immediately after heating operation starts)

3. In HEAT mode, when room temperature is higher than the temperature setting.

4. When the heater control mode is the factory setting and the heater is on, the fan will

operate at high speed.

5. When the unit is in DRY mode.

For LOSSNAY combination

The following 2 patterns of operation are available:

• Run the ventilator together with the indoor unit.

• Run the ventilator independently.

NOTE

With some model configurations, the fan on the indoor unit may come on even when you

set the ventilator to run independently.

NOTE

(for wireless RF thermostat):

• Running the ventilator independently is not available.

• No indication on the remote controller.

SVZ-KP12,18, 24, 30, 36NA

Table of Contents