Installing The Intrusion Switch Module - Dell EMC PowerEdge XR11 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge XR11:
- Installation and service manual (126 pages) ,
- Installation and service manual (124 pages)
Table of Contents
Figure 28. Removing the intrusion switch module
Next steps
Replace the intrusion switch
Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
NOTE:
The procedure to install the intrusion switch module is the same for Rear Accessed and Front Accessed
configurations.
NOTE:
Ensure that you note the routing of all the cables as you remove them from the system board. Route the intrusion
switch cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align and insert the intrusion switch module until it is firmly seated in the slot on the system.
2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the power interposer board (PIB).
40
Installing and removing system components
module.
Safety
instructions.
Before working inside your
system.
- Quick Links:
- Front View of the System
Hide quick links:
Table of Contents
