FX
Series Programmable Controllers
3S
User's Manual - Hardware Edition
5.3
Use of (Built-in USB) Programming Port
Make sure to set the contents described in this section when executing circuit monitor, device monitor,
program reading/writing, etc. in the FX
5.3.1
Installation of USB driver
It is necessary to install the USB driver to execute USB communication using the (built-in USB) programming
port.
For the USB driver installation method and procedure, refer to the following manual.
5.3.2
Setting in GX Works2
1. Double-click the Connection Destination view → [Connection Destination] → [(Connection
target data name)] in the Navigation window of GX Works2.
The [Transfer Setup Connection1] is displayed.
2. Double-click [Serial USB] of the PC side I/F to display [PC side I/F Serial Setting].
3. Select [USB].
4. Click the [OK] button to finish the setting.
PLC using the (built-in USB) programming port and GX Works2.
3S
→ Refer to the GX Works2 Version 1 Operating Manual (Common)
Double-click it.
5 Version Information and Peripheral Equipment Connectability
5.3 Use of (Built-in USB) Programming Port
Select [USB]
1
2
3
4
5
6
7
8
9
10
45