Honeywell Performance Series Quick Installation Manual

Performance Series Cameras

HD41XD2 TDN 1080p IR Rugged Dome Camera

Quick Installation Guide

Document 800-23321 - Rev E - 09/2018

Thank you for purchasing a Honeywell Performance

Series HQA HD41XD2 camera. Follow the instructions

in this guide to install and log in to your camera.

Warnings and Cautions

CAUTION

THIS SYMBOL INDICATES THAT

DANGEROUS VOLTAGE

RISK OF ELECTRIC

CONSTITUTING A RISK OF

SHOCK

ELECTRIC SHOCK IS PRESENT

DO NOT OPEN

WITHIN THE UNIT.

CAUTION: TO REDUCE THE RISK OF ELECTRIC

THIS SYMBOL INDICATES THAT

SHOCK, DO NOT REMOVE THE COVER.

IMPORTANT OPERATING AND

NO USER-SERVICEABLE PARTS INSIDE.

MAINTENANCE INSTRUCTIONS

REFER SERVICING TO QUALIFIED SERVICE

ACCOMPANY THIS UNIT.

PERSONNEL.

WARNING

This device is configured for 12 VDC operation. Do not connect to a higher voltage.

Use only with NRTL-approved Class 2 power supplies.

CAUTION

IR emitted from this product. Do not view directly with optical instruments. Do not

stare directly into the lamp at a distance of less than 3.3 ft (1 m).

CAUTION

Class 1 LED product. Invisible LED radiation (850 nm). Avoid exposure to beam.

Important Safeguards

• Read and keep these instructions.

• Confirm the installation surface can support at least three times the weight of the camera.

• Do not apply power to the camera before completing installation.

• Do not aim the camera toward a bright light source for extended periods.

• Avoid operating the unit under or close to unstable light sources (may cause flickering), or close to

fluorescent lamps or objects reflecting light.

• Do not touch the camera lens.

• Do not drop the camera or subject it to physical shock.

• Do not use a strong or abrasive detergent when cleaning the camera.

• Avoid operating or storing the unit in extremely humid, dusty, hot/cold environments, where the

operating temperature is outside the recommended range of -40°F to 140°F (-40°C to 60°C).

Before You Begin

Before you begin, check that you have received all of the parts listed below. If any parts are missing or

damaged, contact your dealer immediately.

• Camera

• Self-tapping screws (×4)

• Mounting template

• Plastic anchors (×4)

CAUTION

Installation and servicing should be performed only by qualified and experienced

technicians to conform to all local codes and to maintain your warranty.

Preparing the Mounting Surface

1. Apply the mounting template to the mounting surface.

2. Using the mounting template as a guide, drill three pilot holes in the mounting surface, then

hammer the supplied anchors into the holes.

3. Drill a cable entry hole in the mounting surface, then pull the required cables through the hole.

• Hex key (L-wrench)

• Power pigtail

Mounting surface

Anchors

Camera assembly

Self-tapping screws

Dome cover

Security screws

Hex key