Honeywell Performance Series Quick Installation Manual

Performance Series Cameras

H4W4PER3 WDR 4 MP IR Rugged Dome Camera

Quick Installation Guide

Document 800-23289 - Rev B - 06/2017

Thank you for purchasing a Honeywell Performance

Series IP camera. Follow the instructions in this

guide to install and log in to your camera. For

instructions on configuring the camera, refer to the

user guide on the CD that came with your camera. If

you require additional assistance, call the number

listed for your region on the back cover.

Warnings and Cautions

THIS SYMBOL INDICATES THAT

CAUTION

DANGEROUS VOLTAGE

RISK OF ELECTRIC

CONSTITUTING A RISK OF

SHOCK

ELECTRIC SHOCK IS PRESENT

DO NOT OPEN

WITHIN THE UNIT.

CAUTION: TO REDUCE THE RISK OF ELECTRIC

THIS SYMBOL INDICATES THAT

SHOCK, DO NOT REMOVE THE COVER.

IMPORTANT OPERATING AND

NO USER-SERVICEABLE PARTS INSIDE.

MAINTENANCE INSTRUCTIONS

REFER SERVICING TO QUALIFIED SERVICE

ACCOMPANY THIS UNIT.

PERSONNEL.

WARNING

To ensure compliance with electrical safety standards this product is intended for

use with a Listed Power Adapter marked with "Limited Power Source", "LPS", on the

unit, output rated 12 VDC, minimum 0.33A, Tma=60Deg.C or from Power over

Ethernet (PoE) provided by Listed Information Technology Equipment meeting the

IEEE 802.3af PoE standard.

CAUTION

The Ethernet connection is not intended to be connected to exposed (outside plant)

networks. Do not connect two power sources to the camera at the same time.

CAUTION

Invisible LED radiation (850 nm). Avoid exposure to beam.

Important Safeguards

• Read and keep these instructions.

• Confirm the installation surface can support at least three times the weight of the camera.

• Do not apply power to the camera before completing installation.

• Do not aim the camera toward a bright light source for extended periods to prevent damage to the

imager.

• Avoid operating the unit under or close to unstable light sources (may cause flickering), or close to

fluorescent lamps or objects reflecting light.

• Do not touch the camera lens.

• Do not drop the camera or subject it to physical shock.

• Do not use a strong or abrasive detergent when cleaning the camera.

• Avoid operating or storing the unit in extremely humid, dusty, hot/cold environments, where the

operating temperature is outside the recommended range of -22°F to 140°F (-30°C to 60°C).

Before You Begin

Before you begin, check that you have received all of the parts listed below. If any parts are missing or

damaged, contact your dealer immediately.

• Camera

• Allen key (L-wrench)

• Installation CD

• Self-tapping screws (×3)

CAUTION

Installation and servicing should be performed only by qualified and experienced

technicians to conform to all local codes and to maintain your warranty.

Preparing the Mounting Surface

1. Apply the mounting template to the mounting surface.

2. Using the mounting template as a guide, drill three pilot holes in the mounting surface.

3. Hammer the supplied anchors into the holes.

4. Drill a cable entry hole in the mounting surface.

5. Pull the required cables through the cable entry hole.

• Plastic anchors (×3)

• Mounting template