Ipv4 Filter - Bosch MIC IP ultra 7100i User Manual
Hide thumbs
Also See for MIC IP ultra 7100i:
- User manual (96 pages) ,
- Installation manual (72 pages) ,
- Instruction manual (72 pages)
Table of Contents
MIC IP ultra 7100i │ MIC IP starlight 7100i
Port
Enter the port address for the stream here.
Streaming
Click the checkbox to activate multicast streaming mode. An activated stream is marked with a
check. (Streaming is typically not required for standard multicast operation.)
Multicast packet TTL
You can enter a value to specify how long the multicast data packets are active on the
network. This value must be greater than one if multicast is to be run via a router.
IGMP version
You can define the multicast IGMP version to comply with the device.
Click Set to apply the changes.
8.7
IPv4 Filter
Use this setting to configure a filter that allows or blocks network traffic that matches a
specified address or protocol.
IP Address 1 / 2
Enter the IPv4 address that you want to allow or block
Mask 1 / 2
Enter the subnet mask for the appropriate IPv4 address.
Bosch Security Systems
User Manual
Network | en
59
2020-11 | 1.4 |
- Quick Links:
- Configuration
Hide quick links:
Table of Contents
