Allen-Bradley 140G Installation Manual
Earth leakage protector for 140g-k
Hide thumbs
Also See for 140G:
- Manual (12 pages) ,
- Installation instruction (8 pages) ,
- Quick start manual (8 pages)
Quick Links
DIR 1000436R0507 Version 03 - 140G-K-ELP
Earth leakage protector for 140G-K
Sganciatore differenziale
Auslöser differenziale
Declencheur differenziale
Relé differenziale
剩余电流脱扣器
Installation - Installazione - Instalación
Instalação -
WARNING:
To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
Vor Installations- oder Servicearbeiten Stromversorgung zur
WARNUNG:
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT:
Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la
norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes. (Cumpra as exigências da norma NFPA70E).
警告：感電事故防止のため、取付けまたは修理の際は電源から取り外してく
ださい。適切なケース内に取付けてください。また、汚染物質がないことを
確認してください。（NFPA70Eの要件に従ってください）
警告：为了防止触电，在安装或维修之前必须先切断电源。安装在合适的设备
箱内。防止接触污染 。符合NFPA70E要求）
物
1
DIR 1000436R0507 Version 03
-
CLACK
Plug
connector
Screw
End cap kit
1 2 mm (0.47")
x4
Earth leakage
protector
2
Bul. 140G/140MG
Side
Escutcheon
LENGTH
dia.
4
Earth
Leakage shunt
Installation
screw
B -Washer
A -Spacer
x4
CH 8
LENGTH
M
22 mm (0.87") M 1 0
Frontal
cover
Related Manuals for Allen-Bradley 140G
Summary of Contents for Allen-Bradley 140G
- Page 1 Bul. 140G/140MG DIR 1000436R0507 Version 03 - 140G-K-ELP Earth leakage protector for 140G-K Sganciatore differenziale Auslöser differenziale Declencheur differenziale Relé differenziale 剩余电流脱扣器 Installation - Installazione - Instalación Plug Instalação - Side WARNING: To prevent electrical shock, disconnect from power source before connector installing or servicing.
- Page 2 CH 8 LENGTH 22 mm (0.87") M 1 0 DIR 1000436R0507 Version 03...
- Page 3 CH 8 142 lb-in LENGTH 16 Nm 22 mm (0.87") M 1 0 DIR 1000436R0507 Version 03...
- Page 4 LENGTH dia. 1 2 mm (0.47") 10.6 lb-in 1.2 Nm 140G-K LSI-LSIG 7.1 lb-in 0.8 Nm DIR 1000436R0507 Version 03...
- Page 5 4.4 lb-in 0.5 Nm - Operation to be performed if the "SO" button is used. see fig.22 - Operazione da effettuare in caso di utilizzo pulsante SO. vedi fig.22 - Vorgang, der bei benutzung der taste "SO" auszuführen ist. siehe abb.22 - Opération a effectuer en cas d'utilisation du bouton-poussoir "SO".
- Page 6 TEST: only for insulation test of the installation Run the insulation test with EL SNT disconnected and indicator in the TEST POSITION. TEST: solo per prova di isolamento impianto Effettuare il test d'isolamento con EL SNT disconnessa e indicatore in posizione TEST TEST: nur für isolationsprüfung der Anlage Die Isolationsprüfung mit abgeklemmter EL SNT durchführen und der Anzeiger in Position TEST.
- Page 7 - Button to TEST the earth leakage protector. - Pulsante per TEST sgancio differenziale. - TEST-Taste zur Auslösung der Fehlerstrom- Schutzeinrichtung. - Bouton-poussoir pour l'ESSAI de déclenchement du différentiel. - Pulsador para PRUEBA disparo diferencial. - 的脱扣试验按钮 Push 按 LED: Fixed light =>...
- Page 8 LEGEND LEGENDA ZEICHENERKLÄRUNG LÉGENDE LEYENDA = Pushbutton or contact for opening the circuit-breaker. The use of twisted pair cable with a cross section of 0.5 mm² and up to 250 m long is recommended (for greater lengths, contact Rockwell Automation) = Pulsante o contatto per l’apertura dell’interruttore.
- Page 9 4.52" 4.52" 2.54" 2.5" WITH ESCUTCHEON 115 mm 115 mm 64.5 mm 63.5 mm 4.21" 4.21" 2.38" 2.14" 3.66" 0.91" 10.92" WITHOUT ESCUTCHEON 107 mm 107 mm 60.5 mm 54.5 mm 93 mm 23.25 mm 277.5 mm DIR 1000436R0507 Version 03...
- Page 10 Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc. Trademarks not belonging to Rockwell Automation are property of their respective companies. Rockwell Automation maintains current product environmental compliance information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/ sustainability-ethics/product-environmental-compliance.page Publication 140G-IN007D-MU-P - April 2016 DIR 1000436R0507 Version 03 (L9038) - B0822 Copyright ©...