Table of Contents
HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Procedure
Step 1 Loosen and remove the screw of the ground terminal on the lower left of the USG front panel.
Step 2 Align the M4 end of the PGND cable with the opening of the ground terminal and tighten the
screw.
Step 3 Connect the M6 end of the PGND cable to the ground terminal of the cabinet or workbench.
Figure 2-38 Connecting a PGND cable
----End
Follow-up Procedure
Verify the following after the cabling is complete:
2.4.3 Installing an Expansion Card
This section describes how to install an expansion card and avoid any damage.
Context
Issue 03 (2015-01-26)
Phillips screwdriver
Multimeter
The PGND cable is securely connected to the ground terminal.
The electrical resistance between the ground terminal and ground point is less than 5
ohm on a multimeter.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Installation
204
- Quick Links:
- Device Overview
- Usg6300 Product Series
Hide quick links:
Table of Contents
