Cleaning The Burner And Heat Exchanger; Cleaning The Burner; Cleaning The Heat Exchanger - Bosch Condens 7000 F Installation And Maintenance Instructions For The Contractor
Gas-fired condensing boiler
Hide thumbs
Also See for Condens 7000 F:
- Operating instructions for users (20 pages) ,
- Operating instructions for users (20 pages)
Table of Contents
Inspection and maintenance
11.8
Cleaning the burner and heat exchanger
11.8.1 Cleaning the burner
If there is heavy contamination, the burner rod can be separated from
the mixture manifold and a blow gun with a long, angled blow pipe can be
used to blow them off from the inside and outside using a reasonable
amount of compressed air (max. 3 bar).
▶ Re-install the burner rod with a new gasket.
11.8.2 Cleaning the heat exchanger
DANGER:
Danger to life through escaping flue gas!
▶ During installation, look out for faulty gaskets and ensure they are
seated correctly. Replace faulty gaskets.
▶ Replace the gaskets as described ( Chapter 11.11.3, page 42).
▶ Dry and/or wet clean the heat exchanger.
▶ Shut down the heating system ( Chapter 9.1, page 30).
▶ Close the gas main shutoff valve or gas isolator.
▶ Allow floor standing boiler to cool down.
▶ Remove the front panels and corresponding side panels.
▶ Place the tundish that collects dirt and condensate residues under
the condensation catch pan.
▶ Pull the siphon [1] off the drainage connection of the condensation
catch pan [2] and out of the drain pipe. Turn slightly sideways in
doing so.
2
1
Fig. 47 Removing the siphon
[1]
Siphon
[2]
Condensation catch pan outlet
▶ Unscrew the screws on the cover of the condensation catch pan
(with boiler rating 150-300 kW).
▶ Remove the cover.
1
Fig. 48 Removing the cover of the condensation catch pan (illustration
shows boiler size 150-300 kW)
[1]
Cover of condensation catch pan
38
▶ Remove the dirt trap: press the bottom tabs slightly together so the
dirt trap can be lifted up and out of the drainage connection.
▶ Rinse the dirt trap and siphon under running water.
Boiler sizes 75-100 kW do not have a dirt trap and are equipped with a
cleaning pipe socket with cap instead of the cover
Fig. 49 View of condensation catch pan without cover
[1]
Dirt trap
0010012553-001
Fig. 50 Dirt trap following removal
[1]
Dirt trap
0010012528-001
1
Condens 7000 F – 6720871560 (2019/11)
0010013911-001
1
0010013912-001
Hide quick links:
Table of Contents
