Dyndns - Bosch FLEXIDOME IP 3000i IR User Manual

FLEXIDOME IP 3000i IR | FLEXIDOME IP micro

3000i | DINION IP 3000i IR | FLEXIDOME IP turret

3000i IR

To limit connections to SSL encryption, set the Off option in the HTTP browser port and the

RCP+ port. This deactivates all unencrypted connections allowing connections on the HTTPS

port only.

Configure and activate encryption for media data (video, audio, metadata) on the Encryption

page.

Minimum TLS version

Select the version for minimum Transport Layer Security (TLS).

Allow HTTP basic authentication

Select On if you want to allow HTTP basic authentication. This is a less secure authentication

option where passwords are transmitted in clear text. This option should only be used if the

network and system are otherwise secured.

HSTS

Select this option to use the web security policy HTTP Strict Transport Security (HSTS) to

provide secure connections.

RCP+ port 1756

Activating RCP+ port 1756 allows unencrypted connections on this port. To allow only

encrypted connections, set the Off option to deactivate the port.

Discovery port (0 = Off)

Enter the number of the port that you want to discover.

To deactivate the port, enter 0.

Interface mode ETH

If necessary, select the Ethernet link type for interface ETH. Depending on the device

connected, it may be necessary to select a special operation type.

Network MSS [Byte]

Set the maximum segment size for the IP packet's user data here. This gives the option to

adjust the size of the data packets to the network environment and to optimize data

transmission. In UDP mode, comply with the MTU value set below.

Network MTU [Byte]

Specify a maximum value in bytes for the package size (including IP header) to optimize data

transmission.

Click Set to apply the changes.

4.7.3

A dynamic Domain Name Service (DNS) allows you to select the unit via the Internet using a

host name, without having to know the current IP address of the unit. You can enable this

service here. To do this, you must have an account with one of the dynamic DNS providers and

you must register the required host name for the unit on that site.

Note:

For information about the service, registration process and available host names refer to the

provider.

Provider

Select your dynamic DNS Provider from the drop-down list.

Host name

Enter the host name registered for the unit.

Bosch Security Systems B.V.

User manual

Configuration | en

47

2020-01 | V02 | DOC