Remove Power Module - Emerson Rosemount 648 Reference Manual

Reference Manual

00809-0200-4648

Figure 2-18: Example 2: Falling Alert

Field Communicator

To configure the process alerts with a Field Communicator, perform the following

procedure:

Procedure

1. From the HOME screen, follow the Fast Key sequence, 2 Configure → 1 Guided

2. Select 2 for Hi-Hi Alarm, or Select 3 for Hi Alarm, or Select 4 for LO Alarm, or

3. If the alarm is disabled, select 1 Enable and press Enter. If the alarm was previously

4. Enter the alarm limit and press Enter.

5. Enter the alarm deadband and press Enter.

2.10

After the sensor and network have been configured, remove the Power Module and

replace the transmitter cover. The Power Module should be inserted only when the device

is ready to be commissioned. Use caution when handling the Power Module. The Power

Module may be damaged if dropped from heights in excess of 20 feet.

Rosemount 648 Wireless

Alert "OFF"

Alert "ON"

Deadband

Setup → 1 Guided Setup.

Select 5 for LO-LO Alarm and press Enter.

enabled, select 2 Leave Enabled and press Enter.

Alert "OFF"

Time

Configuration

May 2020

Assigned Value

Alert Set Point

31