Table of Contents
5A-37 Automatic Transmission/Transaxle:
11) Install reverse brake reaction plate so that its lug with
dent (1) comes to specified position as shown in
figure.
12) Using screwdriver with vinyl tape or the like wound at
its tip, install retaining reaction plate ring (1). After
installation, check that ring is in groove securely.
13) After confirming that lugs of all brake plates and
brake discs are in grooves securely, hold retaining
ring (1) of planetary sun gear, install center support
assembly by aligning bolt holes (2) in center support
and transmission case.
NOTE
Unless retaining ring of planetary sun gear is
held, brake valve gets off center support and
that will make it impossible to align fluid
holes with bolt holes.
IYSQ01510242-01
1
14) Tighten center support bolts by certain amount at a
time till specified tightening torque is obtained.
I5JB0A510132-01
Tightening torque
Center support bolt: 26 N·m (2.6 kgf-m, 19.0 lb-
ft)
1
I5JB0A510084-01
1
2
I5JB0A510133-01
IYSQ01510246-01
Table of Contents
Troubleshooting
