Table of Contents
DTC C1213: Transfer Switch Circuit Open
Wiring Diagram
[A]
12
26
25
[A]: 4WD control module connector "E91" (viewed from harness side)
[B]: Transfer switch connector "G59" (viewed from harness side)
DTC Detecting Condition and Trouble Area
DTC detecting condition
Transfer switch combination different from specification is
detected for more than 0.5 seconds.
DTC Confirmation Procedure
1) Clear DTC using scan tool.
2) Select transfer switch to "4H" position and keep its position for 10 seconds. Similarly select transfer switch to "4H-
lock", "N" and "4L-lock" position.
3) Check DTC.
Troubleshooting
Step
1
Was "4WD control system check" performed?
2
Transfer switch circuit check
1) Disconnect transfer switch connector "G59" with ignition
switch OFF.
2) Check for proper connection to "G59-2", "G59-3" and
"G59-4" terminals of transfer switch connector.
3) If connection is OK, measure voltage between "G59-2",
"G59-3" or "G59-4" terminal of transfer switch connector
and vehicle body ground with ignition switch ON.
Is it 10 – 14 V?
Transfer: Motor-Shift Type (Transfer with Shift Actuator) 3C-28
1
12V
E91-18
E91-19
E91-20
11
10
9
8
7
6
5
4
19
24
23
22
21
20
18
Action
LT GRN
BLU/BLK
BLU/ORN
[B]
3
2
1
17
16
15
14
13
• Transfer switch
• Transfer switch circuit
• 4WD control module
Go to Step 2.
Go to Step 3.
2
G59-2
G59-3
G59-4
6
5
4
3
2
1
1. 4WD control module
2. Transfer switch
Trouble area
Yes
Go to "4WD Control
System Check: Motor-
Shift Type (Transfer with
Shift Actuator)".
Go to Step 4.
S5JB0E3314014
I5JB0A332016-01
No
Table of Contents
Troubleshooting
