Table of Contents
You will be asked to drive the route.
buttons on the rocker switch 7 to select START.
7
Use the
/
8
Carry out the steps as instructed by the system.
Carrying out the system test
You have the option of carrying out a system test. The system checks the GPS
antenna and whether the reversing signal and the vehicle ignition are correctly
connected to the system.
1
Select SYSTEM TEST menu item in the INSTALLATION setup menu.
Press the OK button 8.
2
3
Choose between SENSOR TEST, INTERNAL TEST and CALIBRAT. DATA.
The displays containing the corresponding test results are shown.
Activating / deactivating the code LED
You can activate the code LED to indicate that your TravelPilot is theft protec-
ted. The code LED is located on the ON button 2. If CODE-LED is activated in
the setup menu, the ON button 2 flashes when the unit and vehicle ignition are
turned off.
To activate / deactivate the code LED,
1
select the CODE-LED menu item in the setup menu and
keep pressing the OK button 8 until the required ON or OFF setting is
2
displayed.
The code LED is activated / deactivated
INTRODUCTION
NAVIGATION
RADIO MODE
CD MODE
INSTALLATION
SYSTEM TEST
CALIBRATION
GPS STATUS
SETTINGS
INSTALL
CODE-LED
DEFAULT SET.
FM-SEEK
KEYCARD
CD CHANGER
SETUP
ON
SENS
105
INDEX
Hide quick links:
Table of Contents
