Table of Contents
Quick Links
Table of Contents
Related Manuals for Blaupunkt ACM 5450
Summary of Contents for Blaupunkt ACM 5450
- Page 1 Operating instructions ACM 5450...
-
Page 3: Table Of Contents
Table of contents Short instructions ... 15 Important notes ... 17 Precautions ... 17 Traffic safety ... 17 Installation/Connection ... 17 Anti-theft protection ... 18 Security code ... 18 Entry of a wrong code number ... 18 Switching on security coding ... 18 Re-start following an interruption of the power supply ... -
Page 4: Short Instructions
Short instructions 1 On / Off: Turn the knob. To adjust the volume: Turn the knob. 2 SRC (Source) To toggle between the connected audio sources, e.g. tape, radio, AUX or CD changer (optional). 3 AUD – audio To adjust the BASS TREBLE BALANCE (left/right volume) - Page 5 To recall a station: Select the memory bank with the FM button and press the corresponding preset button briefly. Extra function: Coding: Read chapter “Anti-theft pro- tection” first. Buttons 1, 2, 3, 4 - To enter the four- digit code. Press each of the buttons as many times as required until the code num- ber given in the car radio passport ap-...
-
Page 6: Important Notes
If you would like to install this equipment yourself or add any new components, please read the enclosed installation and connec- tion instructions carefully first. Do not ground the loudspeaker outputs! Use only the accessory and replacement parts approved by Blaupunkt. -
Page 7: Anti-Theft Protection
(coding system is activated) • Turn on the radio. The display shows “CODE”. • Enter the code number given in the Blaupunkt car radio passport and con- firm (see example under “Switching on security coding”). The unit is now ready for use. -
Page 8: Switching Off Security Coding
Switching off security coding • Turn off the radio. • Press preset buttons 1 and 4 simul- taneously and hold down while • switching the set on again. The display shows “CODE”. • Now enter the code number to be found in the car radio passport and confirm (see example under “Switching on security coding”). -
Page 9: Selecting A Station
If you leave the service area of the regional programme tuned into, or if you would like to take advantage of the full RDS service, switch to “REG OFF”. • Press the AF button for approximately 2 seconds until “REG OFF” appears. When active, “REG ON”... -
Page 10: Automatically Storing The Strongest Stations With Travelstore
Automatically storing the stron- gest stations with Travelstore You can automatically store the five most powerful FM stations of your current recepti- on area sorted according to their signal strength. This function is particularly convenient on longer trips. • Press the TS button briefly. The radio will search for the strongest FM stations and store them on the memory bank “T”... -
Page 11: Automatic Seek Tuning Start
Automatic seek tuning start Prerequisite: The priority for traffic announcements has been activated. When leaving the reception area of the tuned in traffic programme station while listening to a tape or CD or after having turned down the volume completely, the system will automa- tically start searching for a new TA program- If no such station is found within approxima- tely 30 seconds, tape or CD operation will be... -
Page 12: Changing The Tape Direction
In this case check the condition of the cassette tape. Sometimes it helps to rewind it completely. CD changer control (optional) You can operate the Blaupunkt CD changer CDC-A05 in combination with this car radio. Switching to changer operation with SRC on the car radio Make sure that a magazine is inserted. -
Page 13: Appendix
Appendix Mechanism/cassette tapes To avoid possible problems, you should not use cassette tapes longer than 60 or 90 minutes (C60/C90). Store your tapes in a cool place away from dirt, dust and tempera- tures exceeding 50 ° Celsius. Allow very cold tapes to warm up before playing them in order to avoid uneven tape transport. - Page 14 1/96 Pf Blaupunkt-Werke GmbH Bosch Gruppe K7/VKD 8 622 400 073...