Figure 41 Rear View Of A Controller Enclosure (When The Eternus Dx100 S5/Dx200 S5 Is Installed With Only One Controller) - Fujitsu ETERNUS DX S5 Series Configuration Manual
Hybrid storage systems
Hide thumbs
Also See for ETERNUS DX S5 Series:
- Design manual (335 pages) ,
- Operation manual (basic (135 pages) ,
- Configuration manual (75 pages)
Table of Contents
A. Component Names
Controller Enclosure
■
ETERNUS DX100 S5/DX200 S5
Figure 41
Rear View of a Controller Enclosure (When the ETERNUS DX100 S5/DX200 S5 Is Installed with Only
One Controller)
1
2
3
CM#0
CA#0
PSU#0
1
Controller (CM#0) (refer to
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3
Host interfaces (CA#0, CA#1) (refer to
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5
RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7
Cover
Remove this when installing an additional controller (optional).
8
Power supply units (PSU#0, PSU#1) (refer to
4 5
3
6
CA#1
8
"■ Controllers" (page
"■ Host Interface" (page
7
PSU#1
8
230))
237))
"■ Power Supply Units" (page
221
235))
Configuration Guide (Basic)
Hide quick links:
Table of Contents
