Page 3
FMST-FXV(E) Installation Manual Installation Instructions for FMST-FXV(E) Series Detectors (FMST-FXV-11E,FMST-FXV- 11E/CN,FMST-FXV-22E,FMST-FXV-22E/CN,FMST-FXV-33E,FMST-FXV-33E/CN,FMST-FXV-44E,FMST-FXV-44E/CN) The Installation Sheet provides practical information for mounting, piping and cabling FMST-FXV series of Air Sampling Smoke Detector only. Full information is published in the Product Guide (Document number is 29330) which include installation instructions, product use, warnings for safe use and warranty details.
Page 4
FMST-FXV(E) Installation Manual Step 3: Move down detector until groove (1) or groove (2) and (3) get hooked. ( ) i s for FMST-FXV(E) dual pipe product series and (B) is for FMST-FXV(E) four pipe product series. ( A) FMST-FXV(E) 步...
Page 5
FMST-FXV(E) Installation Manual (1) Inlet 1 (Left);(2) Inlet 2 (Right);(3) Cable entry hole; (4) Ethernet (5) Exhaust Hole. 管 1;(2) 管 2;(3) 电 源 线 孔 ; (4)Ethernet 接 口 , (5) 排 气 孔 。 FMST-FXV(E) four pipe product series Inlets and wire connection holes are described as below: FMST-FXV(E) 四...
Page 6
FMST-FXV(E) Installation Manual Fig.7 Step6:Terminal Wiring The Termination Card is available with 6 relays for the FMST-FXV(E) dual pipe product series, and 12 relays for FMST- FXV(E) four pipe product series. Use the appropriate local wiring standards to connect the detector wiring. Factory default relays setting for single terminal board is configured as Minor fault,Major fault,Fire2, Fire1, Action, Alert.
Page 7
FMST-FXV(E) Installation Manual Fig.9 Ensure that : t he exhaust is open, the pipes are clear. All sampling holes have been drilled. Connect 24V DC power. Restore front cover and tighten screws. Restore termination cover and screw covers. 确 保 : 排 气 口 处 于 打 开 状 态 , 采 样 管 洁 净 , 所 有 采 样 孔 都 已 钻 好 。 连 接 24V DC 电...
This manual is also suitable for:
Fmst-fxv-11eFmst-fxv-22eFmst-fxv-44eFmst-fxv-11e/cnFmst-fxv-22e/cnFmst-fxv-33e...
Show all