Table of Contents
Do not store in locations where the temperature may
N
exceed 40 °C.
Charge only at ambient temperatures between 4 °C and
N
40 °C.
Charge only using the charger provided with the tool.
N
When disposing of batteries, follow the instructions given
N
in the section "Protecting the environment".
Under extreme conditions, battery leakage may occur.
N
When you notice liquid on the battery, proceed as
follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
- In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid, a 25-30% solution of
N
potassium hydroxide, can be harmful. In case of skin
contact, immediately rinse with water. Neutralise with a
mild acid such as lemon juice or vinegar. In case of eye
contact, rinse abundantly with clean water for at least
10 minutes. Consult a physician.
Do not incinerate the battery.
N
Do not attempt to charge damaged batteries.
N
Chargers
Use your Black & Decker charger only to charge the
N
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
N
Have defective cords replaced immediately.
N
Do not expose the charger to water.
N
Do not open the charger.
N
Do not probe the charger.
N
The charger is intended for indoor use only.
Additional safety instructions
Warning! The tool can cause serious injury.
N
Never allow children to use the tool.
N
Only use the tool in daylight or good artificial light.
N
Keep hands and feet away from the cutting means at all
N
times, especially when switching on the motor.
Be sure you know how to stop the tool quickly in case of
N
emergency.
Read the instruction manual before use.
Warning! The cutting elements continue to rotate
after the motor is switched off.
Wear safety glasses or goggles when operating this
tool.
Wear ear protection when operating this tool.
Wear gloves when operating this tool.
Do not expose the tool to rain or high humidity.
Never touch the blades while the tool is running.
N
Never attempt to force the blades to come to a standstill.
N
Do not put the tool down until the blades have come to a
N
complete standstill.
Regularly check the blades for damage and wear. Do not
N
use the tool when the blades are worn or damaged.
Take care to avoid hard objects (e.g. metal wire, railings)
N
when trimming. Should you accidentally hit any such
object, immediately switch the tool off and check for any
damage.
Should the tool start to vibrate abnormally, immediately
N
switch it off and check for any damage.
If the tool stalls, immediately switch it off.
N
After use, place the blade sheath supplied over the blades.
N
Store the tool, making sure that the blade is not exposed.
Always ensure that all guards are fitted when using the
N
tool. Never attempt to use an incomplete tool or a tool
with unauthorised modifications.
Be aware of falling debris when cutting the higher slides
N
of a hedge.
While operating the machine always be sure of a safe
N
and secure operating position especially when using
steps or a ladder.
Electrical safety
Your charger has been designed for a specific mains voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Your charger is double insulated in accordance with
EN 60335; therefore no earth wire is required.
This appliance is not intended for use by young or infirm
N
persons without supervision. Children must be supervised
to ensure they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the
N
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
1. On/off switch
2. Lock-off button
3. Blade release button
5
Table of Contents
