Pre-Positions And Tours - Bosch MIC IP fusion 9000i Operation Manual

MIC IP fusion 9000i

2.

3.

4.

5.

Note: Tour B is now intended for use with the 'IVA while moving' functions.

Compass

The camera allows a user to display the compass heading of the camera in the lower-right

corner of the image display. The camera displays the cardinal or intercardinal (N, NE, E, SE, S,

SW, W, NW) heading in which the camera is pointing.

Notice!

The compass feature is not compatible with Bosch's Intelligent Tracking feature. If Intelligent

Tracking is activated, the camera automatically disables the display of the compass heading.

Once Intelligent Tracking is deactivated, the camera returns the compass heading to the

display.

You must first calibrate the camera to North before the camera displays accurate compass

headings. The camera uses this calibration, usually set to magnetic North, as the zero degree

pan position and as the North compass heading. The camera then displays the compass

heading based on the number of degrees from the North calibration point.

To set the North calibration point:

1.

2.

3.

North point

–

–

5.9

The camera can store up to 256 preset scenes. You can define the individual scenes that

comprise a Pre-position Tour.

You define individual pre-position scenes, then use these scenes to define the Pre-position

Tour. The tour starts from the lowest scene number in the tour and progresses sequentially to

the highest scene number in the tour. The tour displays each scene for a specified dwell time

before advancing to the next scene.

By default, all scenes are part of the Pre-position Tour unless removed.

To define a Pre-position Tour:

1.

2.

3.

4.

Bosch Security Systems

Click Yes to overwrite the existing tour movements.

Click the View Control link, under the image cameo, to access the directional and zoom

controls.

Use the View Control dialog box to make the necessary camera movements.

Click the Stop Recording button to save all actions.

Determine the North compass heading, then move the camera to that position.

Select the radio button On for the parameter Compass.

Click the button next to North point to set the calibration point.

Click the Set button to overwrite the existing North point. A dialog box appears with the

message, "Overwrite North point?" To confirm, click OK. To cancel, click Cancel.

Click the Clear button to reset the North point to factory defaults. A dialog box appears

with the message, "Reset North point to factory defaults?" To confirm, click OK. To

cancel, click Cancel.

Create the individual pre-positions.

By default, all scenes in the list Pre-positions are in the Pre-position Tour.

To remove a pre-position from the tour, select the pre-position in the list and uncheck the

box Include in standard tour (marked with *).

Select a dwell time from the drop-down list Standard pre-position tour.

To start the Pre-position Tour:

Return to the Live page.

Click AUX Control.

Operation Manual

Camera | en

33

2019-11 | 1.2 |