Cisco Catalyst IW6300 Series Hardware Installation Manual page 33

Installing the Access Point

Figure 12: Screw Hole Locations on the Mounting Bracket

1

2

Step 2

Use four customer-supplied screws and optional screw anchors to attach the mounting plate to the mounting

surface.

Note

Step 3

Screw a M8 x16 bolt in the top support bolt hole on each side the access point. Do not screw the bolt all the

way in; leave approximately a 0.25 inch (0.635 cm) space.

Step 4

Position the two bolts on the access point onto the hands-free attach points on each side of the mounting

bracket. Ensure that the access point cover is facing out. Never leave the access point unattended until fully

installed.

Mounting slots

Mounting holes

If necessary, use suitable screw anchors and an exterior-grade plywood backboard to mount the

access point to stucco, cement, or drywall.

Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide

Mounting the Access Point on a Wall

3

Hands-free attach point

4

Second support bolt hole

25