Installing The Access Point; Mounting On A Wall Or A Pole; Installation Option - Cisco Catalyst IW6300 Series Hardware Installation Manual
Heavy duty access point
Show thumbs
Also See for Catalyst IW6300 Series:
- Getting started (20 pages) ,
- Installing manual (28 pages)
Table of Contents
Installing the Access Point
This chapter describes how to install the access point.
•
•
•
•
•
•
•
Mounting on a Wall or a Pole
This section provides instructions for the physical installation of your access points. Personnel installing the
access point must understand wireless access points and bridging techniques and grounding methods.
Caution
All installation methods for mounting an access point on any wall surface is subject to the acceptance of local
jurisdiction.
Installation Option
The Cisco Catalyst IW6300 Heavy Duty Series Access Points are installed using the pole mount installation
kit (IOT-ACCPMK), which is used for pole or wall installations.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Refer to these sections for installation details:
Mounting on a Wall or a Pole, on page 21
Working with the Access Cover, on page 33
Installing External Antennas, on page 35
Grounding the Access Point , on page 38
Using the Reset Button, on page 39
Powering the Access Point, on page 40
Performing Maintenance, on page 46
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
3
C H A P T E R
21
Hide quick links:
Chapters
Table of Contents
