Quick Links
Keyfob TCC800M, TCC8M
This keyfob can be used with all Domonial
panels from version I onwards, radio
modules CO79, CO79-2 and 5882EUHS
supporting the Alpha protocol and on older
panels that support the V2 protocol (HF
keyfob models). In the latter case, the TCC
keyfob simulates a TC805HF keyfob.
Battery Specification
It is recommended that only the following 3V
battery is used: CR2032 by Panasonic or GP.
LED
LED
LED
B1
B1
B1
B2
B2
B2
B4
B4
B4
B3
B3
B3
TCC Base and Belt Hook
To fix the TCC to a wall, unclip it from its
base and screw the base to the wall, using
the two screw holes (screws not supplied).
To fix it to a belt, slide the belt hook upwards
into the slot provided in the base of the TCC.
Registration and Configuration
1. First, set the panel to registration mode.
- Button 1: Arm
Total Set
- Button 2: Disarm
- Button 3: Arm
Partial Set
- Button 4: System
Status
- SOS: Buttons
1 and 3 send an
immediate alert
when depressed
simultaneously for
2 seconds.
2. To register the TCC keyfob, press
buttons 1 and 3. To register the keyfob with
a different panel, remove and replace the
battery before registering as usual.
Configuration is performed with
a programming tool. Total, Annex or
Total + Annex.
Changing the Battery / Protocol
1. To change the battery, remove
the TCC keyfob from its base and
unscrew the battery compartment with
a screwdriver.
3. To change to V2: While inserting the
new battery, press the Disarm and Part
Arm buttons.
4. To change to Alpha: While inserting
the battery, press the Total Arm and
Disarm buttons.
The LED related to buttons B1 and
B2 pushed will light for 3 seconds then
after they will light off and if
Alpha: LED of B1 and B2 flash for 8s
V2:
LED of B1 and B2 flash for 3s.
The new protocol is retained in memory,
and is not affected by the user changing
the battery.
2. The default protocol
is Alpha, but
depending on the
control panel version,
you may need to
change this to V2.
Related Manuals for Honeywell TCC800M
Summary of Contents for Honeywell TCC800M
- Page 1 Keyfob TCC800M, TCC8M This keyfob can be used with all Domonial 2. To register the TCC keyfob, press panels from version I onwards, radio buttons 1 and 3. To register the keyfob with modules CO79, CO79-2 and 5882EUHS a different panel, remove and replace the supporting the Alpha protocol and on older battery before registering as usual.
- Page 2 Honeywell Security Group - 1198 Avenue du Docteur Maurice Donat BP 1219 06254 Mougins Cedex: Tel: +33 (0) 4 92 94 29 50 Fax: +33 (0) 4 92 94 29 60 © Honeywell International Inc. Certification: To obtain applicable CE compliance Declaration of Conformity, please refer to our web site:...