Table of Contents
4. Function of outdoor unit for commanding ON/OFF of indoor unit group
No.
Function
All the indoor unit groups connected are
simultaneously set to the trial run mode.
Note: Conducting control action, same as
4-1 Cool trial run
All the indoor unit groups connected are
simultaneously set to the trial run mode
Note: Conducting control action, same as
4-2 Heat trial run
Make all the indoor unit groups connected
run simultaneously.
Simultaneously
running
Note: Running content should be as per the
Simultaneously
stopping
4-3
Make individual unit group specified run.
Note: Running content should be as per the
Individually
setting of remote controller. Other indoor
running
unit groups should maintain their original
state.
Make individual unit group specified stop.
Note: Other indoor unit groups should mai-
Individually
ntain their original state.
stopping
Note: This function of "Run/Stop" only indicates the function of signal of run/stop sending out from outdoor unit to
indoor unit group other than the function that the signal is sent out again due to the reason that the indoor unit
group does not submit to the signal first sent out.
Outline
the command usually sent out by the
remote controller.
the command usually sent out by the
remote controller.
setting of remote controller.
Make the entire indoor unit groups
connected stop simultaneously.
Setting troubleshooting method
[setting]
Use SW01 "0", SW02 "11", press SW04 for
over 2 seconds;
[eliminating]
When changing SW01, Sw02 into other
positions, use remote controller to eliminate.
[setting]
Use SW01 "0", SW02 "12", press SW04 for
over 2 seconds;
[eliminating]
When changing SW01, Sw02 into other
positions, use remote controller to eliminate.
[setting]
Use SW01"0", SW02 "14", press SW04 for
over 4 seconds;
[eliminating]
Use remote controller to eliminate.
[setting]
Use SW01 "0", SW02 "14", press SW05 for
over 4 seconds;
[eliminating]
Use remote controller to eliminate.
[setting]
For SW01 "15", set SW02 to the address
number (0~15) of indoor unit to be run, press
SW04 for over 2 seconds
[eliminating]
Use remote controller to eliminate.
[setting]
For SW01 "15", set SW02 to the address
number (1~16) of indoor unit to be run, press
SW05 for over 2 seconds
[eliminating]
Use remote/controller to-eliminate.
37
: http://splitoff.ru/tehn-doc.html
Hide quick links:
Table of Contents
