1. Manuals
  2. Brands
  3. HP Manuals
  4. Storage
  5. NetStorage 6000
  6. Quick start manual

HP NetStorage 6000 Quick Start Manual

Network interface upgrade
Hide thumbs Also See for NetStorage 6000:
1
2
3
4

Quick Links

H
P
N
E
Network Interface Upgrade
NOTES:
•
Use only HP NetStorage 6000 Network Interface Cards for upgrades.
•
For this upgrade, you should choose a time when end-user access is not required for the unit.
Configurations supported:
Any combination of one or two of the following
HP NICs is supported:
•
10/100 bT
•
Dual 10/100 bT
•
Gigabit 1000 Base SX
Each NIC port must be attached to a different subnet.
Trunking is not supported.
Shut Down the System
Open the Case
T
S T O
All manuals and user guides at all-guides.com
R
A.
Shut down the unit using either the front panel interface
or the HP NetStorage web interface.
B.
After system shutdown is complete, turn off the power
switch on the back panel of the unit.
C.
Disconnect both power cords from the back panel of the
unit.
A.
Remove the two screws on the back of the unit that hold
the top in place.
B.
Slide the top backwards, and lift to remove.
A G
E
6
Parts required:
•
New NIC card
Tools required:
•
Phillips screwdriver
•
Electrostatic protection device
0
0
0
loading

Related Manuals for HP NetStorage 6000

Summary of Contents for HP NetStorage 6000

  • Page 1 All manuals and user guides at all-guides.com Network Interface Upgrade NOTES: • Use only HP NetStorage 6000 Network Interface Cards for upgrades. • For this upgrade, you should choose a time when end-user access is not required for the unit. Configurations supported:...
  • Page 2 All manuals and user guides at all-guides.com Add or Remove a NIC Card Unplug the network cable. Unscrew the existing NIC and gently remove it. NOTE: If you are installing the NIC in an unused PCI slot, remove the expansion slot access panel. Insert the New Card Select an open PCI slot.
  • Page 3 Connect the Unit Connect a network cable to the new port(s). Reconnect the two power cords on the back panel of the HP NetStorage unit, and plug them into your power source. Turn on the unit. Press the alarm-reset button on the front panel to turn off the alarm.
  • Page 4 All manuals and user guides at all-guides.com *C4480-90101* C4480-90101...