Table of Contents
Available languages
Available languages
AddITIONAL SAFETY INFORmATION
• Do not use Type 1 flat cut-off abrasive or diamond wheels without proper guard.
WARNINg:
conforms to ANSI S12.6 (S3.19) during use. Under some conditions and duration of
use, noise from this product may contribute to hearing loss.
WARNINg:
glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNINg:
other construction activities contains chemicals known to the state of California to
cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
• c rystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work
with approved safety equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNINg:
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face and
body.
WARNINg:
by the operating action of this tool may cause permanent injury to fingers, hands, and
arms. Use gloves to provide extra cushion, take frequent rest periods, and limit daily time
of use.
WARNINg:
not move inadvertently, roll or cause a tripping or falling hazard. The grinder may
stand upright on the battery pack but may be easily knocked over. Serious personal
injury may result.
WARNINg:
the tool when shut off. If grinding wheel or accessory loosens, it may dismount from the
machine and may cause serious personal injury.
CAUTION:
To reduce the risk of personal injury, use extra care when working
into a corner or edge because a sudden, sharp movement of the tool may be
experienced when the wheel or other accessory contacts a secondary surface or a
surface edge.
• When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. The following table shows the correct
size to use depending on cord length and nameplate ampere rating. If in doubt, use
the next heavier gage. The smaller the gage number, the heavier the cord.
volts
120V 0-25 26-50 51-100
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m
Ampere Rating
More
Than
6
Always wear proper personal hearing protection that
ALWAyS use safety glasses. Everyday eyeglasses are NOT safety
Some dust created by power sanding, sawing, grinding, drilling, and
Use of this tool can generate and/or disperse dust, which may cause
Do not operate this tool for long periods of time. Vibration caused
When not in use, place grinder on a stable surface where it will
The grinding wheel or accessory may loosen during coast-down of
MINIMUM gAUge fOR CORD SeTS
Not more
American Wire Gauge
Than
-
10
18
Total Length of Cord in feet
16
14
6
101-150
12
Table of Contents
