GE Current Lumination IS Series Installation Manual

Lumination

(IS Series)

There are three types of fixtures:

• Starter (ISS series)

• Continuous (ISCseries)

• Independent (IS1 series)

Use Starter Kit in general case. Use Starter SKU if preferred.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Important notes included below and on page 3.

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electricalenclosure.

RISK OF ELECTRIC SHOCK

• Follow all NECand local codes.

• Use only UL approved wire for input/output connections.

Minimum size 18 AWGor 14 AWGfor continuous runs.

• When using multi-branch wire circuits with a shared neutral, do not

operate any circuit with the neutral open. Also ensure all neutral connections • Lorsque vous utilisez des circuits câblés à branches multiples avec un

are secure before energizing the circuit. An open neutral can cause an

overvoltage condition at the luminaire power supply.

Save These Instructions

Use only in the manner intended by the manufacturer. If

you have any questions, contact themanufacturer.

Prepare Electrical Wiring

Electrical Requirements

The LED fixture must be supplied with 120-277VAC,

50/60Hz or 347V, 50/60Hz and protected by a max.

20 ampere circuit breaker. Use min. 75°C supply

conductor. 347V power should only be supplied to

luminaires with voltage code "D".

Grounding Instructions

The grounding and bonding of the overall system

shall be done in accordance with National Electric

Code (NEC) Article 600 and local codes.

LED Luminaire

TM

WARNING/AVERTISSEMENT

RISQUES DE DÉCHARGESÉLECTRIQUES

• Coupez l'alimentation avant d'inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier

d'alimentation électrique.

RISQUES D'INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N'utilisez que des fils approuvés par UL pour les entrées/sorties de

connexion. Taille minimum 18 AWGou 14 AWGpour les rangées continues.

neutre commun, ne mettez aucun circuit en service avec le neutre ouvert.

Assurez-vous également que tous les raccords neutres soit sécurisés avant

de mettre le circuit sous tension. Un neutre ouvert peut causer une condition

de surtension à l'alimentation du luminaire.

Components Supplied:

• Luminaire

• 2 MountingBrackets

• End Caps (2 supplied with IS1 series and ISS series)

Note: In general case, with the Starter Kit, the Starter SKU

will not be required.

Tools and Components Required:

• T15 torx or phillips #2 screwdriver

• UL Listed conduit connections per NEC/CEC

• UL Listed wire connectors

1

Installation Guide

for nominal conduit trade sizes ½" or ¾"

Page

2

3

4

6

10

11