1. Manuals
  2. Brands
  3. Honeywell Manuals
  4. Cell Phone
  5. IntelliPath Series
  6. Installation and setup manual

Section 4: Registration; Registering The Communicator; Registering Through The Alarmnet 360 Website - Honeywell IntelliPath Series Installation And Setup Manual

Commercial fire panel internet and cellular communicator
Hide thumbs Also See for IntelliPath Series:
Table of Contents
                                                

Registering the Communicator

Once you have programmed the communicator, it must be registered to enable the AlarmNet
account. Registering the communicator activates the account with AlarmNet and enables the
security system's control panel to send reports. You can register by using one of the following
methods:
 AlarmNet 360 website
 Test Message / Registration switch
LED
DESCRIPTION
STATUS
ON – Is NOT registered with AlarmNet.
(green)
OFF – Is registered with AlarmNet.
MESSAGE
ON – Message transmission pending.
(yellow)
QUICK PERIODIC BLINK - Normal
SLOW BLINK – In unison with green LED,
Registration in progress.
FAULT
OFF – No fault present.
(red)
You can monitor the registration process by viewing the display LEDs. The TX/RX (yellow) LED
and the REG (green) LED will blink slowly in unison while registration is in progress.
When the registration successfully completes, the communicator enters a normal operating
mode; the REG (green) LED goes out and the TX/RX (yellow) LED is lit to indicate that the
power-on / reset message is waiting to be sent. This message will appear at the receiving
station as "E339 803". The description may read "Trouble – Exp. Mod. Reset". If registration is
not validated within 90 seconds, the communicator times out, and the REG (green) LED will be
lit solid.

Registering through the AlarmNet 360 Website

To register the communicator via the website, go to: AlarmNet360.com
Log in and follow the on-screen prompts.
Please have the following information available:
After the communicator is registered, you may log out of the AlarmNet 360 website.
Primary City ID (two-digit number).
Primary Central Station ID (two-digit hexadecimal number).
Primary Subscriber ID (four-digit number).
MAC ID and MAC CRC number (located on the box and inside the communicator).
 7720P Programming Tool
 Phone
STATUS
MESSAGE
FAULT
17
S E C T I O N
Registration
4
Table of Contents
loading

Related Manuals for Honeywell IntelliPath Series

Related Content for Honeywell IntelliPath Series

This manual is also suitable for:

Intellipath lte-cfvIntellipath lte-cfa

Table of Contents