Table of Contents
Instructions for use and maintenance
4.6.4 Positioning the electrical equipment
The machines are supplied in a standard execution without electrical enclosure, which is designed
and fabricated in relation to the machine's specifications as an optional accessory; however the
machine is equipped with a terminal block which connects the on-board electrical equipment,
excluding the motors.
If an electrical enclosure is supplied, and in any case as a general suggestion, the cabinet containing
the electrical control and power equipment, if separate from the machine, must be located in a room
that is as clean and dry as possible, ventilated, far away from steam, dust in suspension, corrosive
fumes, and in any case its characteristics of protection against external factors must be adequate
for the installation room, whose specifications must be evaluated by the Customer before ordering.
In addition, it is necessary to keep away from sources of heat so as to cause no local overheating
and to permit appropriate cooling of the electrical equipment.
With regard to the type, overall dimensions, weight and installation requirements of the electrical
enclosure, if supplied by GEA Niro Soavi, refer to the wiring diagrams and Technical Specifications
enclosed with Chapter 11 of this manual.
WARNING:
If the electrical enclosure is provided by the client, it will be the client's responsibility to include the
lockable disconnecting device between the machine and the power line.
This manual is owned by GEA Niro Soavi Any reproduction, even partial, is prohibited.
04C100-4C0
81
GEA Niro Soavi
- Quick Links:
- Operating Principle
Hide quick links:
Chapters
Table of Contents
Troubleshooting
