Adusting Headset Ringer Tone Volume; How To Use The Wireless Headset - NEC DT830 Series User Manual
For nec univerge sv9000 series systems
Hide thumbs
Also See for DT830 Series:
- User manual (263 pages) ,
- Quick reference manual (10 pages) ,
- Quick reference card (2 pages)
Table of Contents
ADUSTING HEADSET RINGER
TONE VOLUME
You can adjust the ringer tone volume for the headset
in idle/busy status.
Note:
To provide a ringer tone from the headset, the
system configuration is required. For details, con-
tact the system administrator.
Note:
Ringer tone volume can be adjusted only for the
wired headset which is connected to the terminal
headset connector.
Note:
Ringer tone volume in busy status cannot be
changed when the ringer tone is set to come from
both the speaker and the headset. For details,
contact the system administrator.
To Adjust the Ringer Tone Volume in Idle
Status
STEP 1: Press the Headset key while in idle status to
switch from headset mode to handset mode,
and the Headset key lamp turns off.
STEP 2: Receives a call from another line.
STEP 3: Press Up/Down (
is on.
For Ringer Tone Volume in Busy Status
If other lines are accommodated in the telephone as a
subline, the ring tone volume is lower than normal
when other lines receive calls during a call with the
headset on.
Note:
When you receive an incoming call from other
line while in a conversation with headset, the
ringer tone volume for other lines in headset
mode can be set the same as the normal volume.
For details, contact the system administrator.
DT830 DT430/410
) key while a ringer tone
HOW TO USE THE WIRELESS
HEADSET
DT830 DT430/410
When using Wireless Headset, you can answer a call,
conduct a conversation, or disconnect
the call with hooking operations. This section explains
about the terminal operation using Wireless Headset.
Note:
The Hook key of Wireless Headset must be pro-
grammed in advance. For the programming of
Headset key, contact the system administrator.
Note:
For details on how to connect a telephone and
Wireless Headset, see the manual attached
to the Wireless Headset.
To Answer a Call
STEP 1: Press Hook key of the Wireless Headset
while the ringing tone is on, and the Hook key
lights red. Depending on the installation
phase, you can answer the call by pressing
key instead of Hook key.
Answer
STEP 2: Press Hook key to end the call, and the Hook
key turns off.
105
- Quick Links:
- Face Layout
- Programmable Feature Keys
Hide quick links:
Table of Contents
