Table of Contents
28/60
Installation
1
SB
F
L
L
L
S
1
Fig. 7: Below-reservoir installation A10VO/A10VSO with installation position 1–4
Bosch Rexroth AG, A10VO, A10VSO Series 31, RE 92701-01-B/04.2018
Recommended installation position: 1 and 3.
Because complete air bleeding and filling are not possible in installation positions 2
and 4, the axial piston unit should be air bled and filled in a horizontal position
prior to installation.
2
SB
F
h
t min
h
min
L
1
S
Highest drain port
l, l
1
F
Filling/air bleeding
S
Suction port
Port F is part of the external piping and must be provided on the customer side
to make filling and air bleeding easier.
Table 8: Below-reservoir installation
Installation position
1 (drive shaft horizontal)
2 (drive shaft up)
3 (drive shaft horizontal)
4 (drive shaft down)
7.3.2
Inside-reservoir installation
Risk of damage with inside-reservoir installation!
To prevent damage to the axial piston unit, all plastic parts (e.g. protective plugs,
covers), except for the tamper-proof caps, must be removed prior to installation in
the reservoir.
▶
Remove all plastic parts, except for the tamper-proof caps, before you install the
axial piston unit in the reservoir. Make sure that no parts of them remain in the
reservoir.
Remove the protective plug from the suction port S and open at least
▶
one l port.
Inside-reservoir installation is when the axial piston unit is installed in the reservoir
below the minimum fluid level. The axial piston unit is completely below the
hydraulic fluid.
3
SB
F
h
t min
h
min
L
S
1
h
t min
h
min
SB
Air bleed
F
F
F
F
NOTICE
4
SB
F
h
t min
h
min
S
L
L
1
Minimum required immersion depth
(200 mm)
Minimum required distance to
reservoir bottom (100 mm)
Baffle (baffle plate)
Filling
l (F)
l
(F)
1
l
(F)
1
l (F)
h
t min
h
min
Hide quick links:
Table of Contents
