Table of Contents
MC-E4111-KP47 / MC-E4113-KP47
3. Remove the lead wire (white) connector from the printed
circuit board section. (Fig.16)
4. After fitting a new thermal protector, connect it as shown in
the diagram.
5. Fit the remaining associated components by reversing the
disassembly procedure.
Note: Make sure that the lead wires and the lower body
seal are fitted correctly so that the lead wires do not get
caught between components.
3.8.
P.C.B. Unit (PC Board
w/Component)
1. Remove the three lead wire (white, red, and blue)
connectors from the printed circuit board cover (holder).
(Fig.16)
2. Remove the two screws fixing the printed circuit board
holder to separate the printed circuit board holder A from
the printed circuit board holder that covers the printed circuit
board.
3. Remove the lead wire (black) from the motor terminal on
the printed circuit board U. Then, remove the printed circuit
board cover. (Fig.18)
4. Fit the components by carrying out the disassembly
procedure in reverse.
Note: Make sure that the lead wires are fitted correctly so
that they do not get caught between components.
8
Table of Contents
