Honeywell Lyric RF6FOB Installation Instructions

This bi-directional wireless keyfob is intended for

use with Honeywell controls that support SiX™ series

devices.

PLEASE GO TO THE BOTTOM OF

THE NEXT PAGE FOR FCC/IC

AGENCY STATEMENTS

Enroll and Program the RF6FOB

1. Set Lyric Smart Controller in Programming mode

and go to the Keys enrollment screen.

2. Select the appropriate Key Type for the

application (i.e., 4 Button or 8 Button).

3. Press and release the top 2 buttons on RF6FOB to

activate the enrollment process.

4. The LEDs alternately flash green during

enrollment (typically, about 8 seconds, but may

take longer, depending on signal strength

between the RF6FOB and the control).

5. When the LEDs light solid green for 3 seconds

and the RF6FOB emits a chirp, press the buttons

again to complete enrollment.

Note: If enrollment is not confirmed, press and release the

top two buttons again to restart the enrollment process.

Follow instructions in the Control's programming

guide to program the RF6FOB services.

Note: once enrolled in a system, the RF6FOB cannot be

used with another control panel until it is removed from

the control panel. When removed from a system, the

keyfob will revert to factory default settings.

System Status and Sounder Indications

The RF6FOB can be used to control the Lyric Smart Controller system (e.g., arm, disarm the system); and

receive system status information (armed status, not ready to arm, in alarm, in RF transmission mode, and

more). Refer to the System Status Indications table for details.

LEDs

RED ON steady for 2-3 seconds

RED Flashing slowly for 2-3 seconds

RED Flashing rapidly for 2-3 seconds

GREEN ON steady for 2-3 seconds

GREEN Flashing slowly for 2-3 seconds

Single, quick GREEN flash

OFF

GREEN LEDs Flash alternately for 8

seconds, then ON for 3 seconds

BETA DRAFT IIs – 02/10/15

System Status Indications Table

Sounder

2 beeps

4 beeps

4 beeps

1 beep

silent

silent

1 second beep

chirp for confirmation

*Note: Depending on the signal strength between

the device and the control, the enrollment period

may take longer than 8 seconds.

System Status

System Armed (any mode)

Alarm in progress

System in Panic Mode

Disarmed, Ready to Arm

Disarmed, Not Ready to Arm

RF Transmission

Not Hearing From Panel

RF6FOB Enrollment